Jump to content

Recommended Posts

Posted

guys i turn ecm commands(dispenser on, ecm xmit , aux rel enbl) on but cannot launch either chaff and flares ......any reason for that?:huh::huh::cry::cry:

Posted (edited)

You need to program that in on the EW page. Give me a minute and I will dig out a thread that explains how to do it. You also need to have Master Arm on.

 

It's not complicated and there are some very good reasons why it's done this way.

Edited by Mule
Posted

I’ve got to ask, did you turn on your master arm?

7800x3d, 5080, 64GB, PCIE5 SSD - Oculus Pro - Moza (AB9), Virpil (Alpha, CM3, CM1 and CM2), WW (TOP and CP), TM (MFDs, Pendular Rudder), Tek Creations (F18 panel), Total Controls (Apache MFD), Jetseat 

Posted (edited)

if you have it in bypass the most upward position of the dispenser switch aft/forward will drop 2 of there respected CM's the middle position is programed witch you do with one of your DDIs on the EW page (programs 1-5 prog 5 is always selected as forward and you can have 1, 2, 3 or 4 set as aft) and bottom is off

 

Redkite does a really good video on this like all his others (

) explaining how the countermeasures work in the hornet Edited by CheeseCake
Posted

Make sure you actually have one of the programs selected. Go to EW page and push the OSB under the Mode label. You'll see the status change from standby to program 1,2,3 ect.

 

It's default setting is standby so you'll have to do this every time you power up the dispenser.

DCS F/A-18C :sorcerer:

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...