Jump to content

Recommended Posts

Posted

Thanks so much in advance for creating new campaign for my favorite module, but I am a bit stuck in the first mission, It says put the altimeter to 33, but I dont understand how to do this...and when wolf 1 arrives, says nothing. What I am doing bad?

Intel i9 10850k - MSI Tomahawk 490z - 64 GB DDR4 3000 - HP Reverb G2 - MSI optix Mag321curv 4k monitor - MSI RTX 3080ti - Winwing Orion Throttle base plus F18 stick

Posted

Put your radar altimeter at just under 50 and youll be good to go. Make sure you turn it on first, its the center gauge on the dashboard, and the toggle switch for it is fully aft on the overhead panel.

Intel 13900k @ 5.8ghz | 64gb GSkill Trident Z | MSI z790 Meg ACE | Zotac RTX4090 | Asus 1000w psu | Slaw RX Viper 2 pedals | VPForce Rhino/VKB MCE Ultimate + STECS Mk2  MAX / Virpil MongoosT50+ MongoosT50CM | Virpil TCS+/ AH64D grip/custom AH64D TEDAC | Samsung Odyssey G9 + Odyssey Ark | Next Level Racing Flight Seat Pro | WinWing F-18 MIPS | No more VR for this pilot.
 My wallpaper and skins

On today's episode of "Did You Know", Cessna Skyhawk crashes into cemetery; over 800 found dead as workers keep digging.

Posted (edited)
Thanks so much in advance for creating new campaign for my favorite module, but I am a bit stuck in the first mission, It says put the altimeter to 33, but I dont understand how to do this...and when wolf 1 arrives, says nothing. What I am doing bad?

 

Altimeter setting is not necessary for the mission progress.

It's the barometric altimeter in the top right of the instrument pannel

 

Wolf two is waiting for your radio call. You do not have switched on the air to air radio and set it to Preste 2.

You find the next step necessary for mission progress always in the radio menu F10:smilewink:

 

Don't forget the radio selector switch.

 

"PETER / CO

Switch the ARC-51 for air to air communication to Mode RT+ Guard - and make Shure, frequency is set to 264 MHz which is Preset 2 as well - -

The Radio selector set to 2 so we can talk to our Group leader WOLF 1 - - "

Edited by CHPL

Always happy landings ;)

Posted (edited)

C-130 crashes ?

 

Right at the beginning while waiting for Wulf 1 a C-130 is taking off.

 

Has someone else issues with the C-130? Chrah and mission stuck ?

 

 

 

POSSIBLE REASON AND SOLUTION

 

Ther is only one possible cause the C-130 may crash

That's the AI UH-1 taking off and crossing the runway.

 

Under normal circumstances, there is enough time between both takeoffs.

But if you are very fast during Startup, or you switch the Inverter Switch to MAIN ON "before" the engine is on ground idle.

That may lead to the collision on the runway.

 

I change the triggers anyway today 08.26,19 so that can't be happening again. Will be part of the next campaign update.

Edited by CHPL

Always happy landings ;)

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...