leon737 Posted July 23, 2021 Posted July 23, 2021 When on hot or airborne mission start, the HMD format is missed under SPT pages, probably because the HMD alignment procedure wasn't run (but HMD is anyway properly aligned and running well).
Tholozor Posted July 23, 2021 Posted July 23, 2021 At work so I can't check it at the moment, but I believe the HMD option will appear on the SUPT page after about a minute of being on, or after running the HMD BIT. REAPER 51 | Tholozor VFA-136 (c.2007): https://www.digitalcombatsimulator.com/en/files/3305981/ Arleigh Burke Destroyer Pack (2020): https://www.digitalcombatsimulator.com/en/files/3313752/
leon737 Posted July 23, 2021 Author Posted July 23, 2021 (edited) Correction, not the HMD alignment but the HMD BIT. The problem is the HMD tests are not required on hot or airborne mission start, because the aircraft is prepared behind the scenes, but HMD option is not available. I'll check wheither the option will appear after a while HMD is powered on or not. Edited July 23, 2021 by leon737 1
Swift. Posted July 23, 2021 Posted July 23, 2021 The fact that the HMD shows a GO on the BIT format is misleading then. If it requires a BIT it should say so. 1 476th Discord | 476th Website | Swift Youtube Ryzen 5800x, RTX 4070ti, 64GB, Quest 2
Loophole Posted July 24, 2021 Posted July 24, 2021 I've found that on a hot start you still have to run the JHMCS Bit tests in order to get the HMD page to become available.
maxTRX Posted July 24, 2021 Posted July 24, 2021 10 hours ago, Loophole said: I've found that on a hot start you still have to run the JHMCS Bit tests in order to get the HMD page to become available. Verified. I started in the air and I still had to initiate HMD BIT to make the HMD option show up on SUPT top level page.
Recommended Posts