rudder wheelbrake assignment problem

[markturner1960]

Hi, despite copying over my old config file, when setting up my new PC some assigments are missing. One of these is the wheelbrake to my rudders. Easil;y added you say, but in my case, not. I checked in control panel and its all working fine there.

 

when I go to controls in DCS, and try and assign either an axis or by using the "add" button, no input is picked up when I press the toebrake. So I cant assign it.  Any ideas?

[dburne]

Check closely for a duplicate axis assignment for the wheelbrakes.

[markturner1960]

Thanks, but nothing that I can see Don....

[Brun]

Tried assigning it manually rather than just pressing the brake?

[jackdaw]

59 minutes ago, Brun said:

Tried assigning it manually rather than just pressing the brake?

How?

[Brun]

Using the Key / Button drop down menu.

 

Trial and error to get the right axis, but that shouldn't present too much trouble when there's only three.

[Ermes]

Try to recallibrate the pedals. I had the same problem and that solved it to me.

[markturner1960]

thanks, I was not able to get it to work, using the suggestions, but was able to copy over the relevant section of teh .lua file from my old install and it works! But thanks!