fixed Latest OB ModelViewer2 is Crashing

[RustyGunner]

ModelViewer2, version 2.7.714727, is crashing when adding a model (specifically a collision model).  Steps to reproduce:

1 - Start ModelViewer2
2 - Load model Molniya.edm (DCS World OpenBeta/Bazar/World/Shapes)
3 - Add model Moscow.edm (DCS World OpenBeta/Bazar/World/Shapes)
Result: both models will show correctly. (you will need to offset one of the two models to see both)

4 - Close ModelViewer2 and Restart ModelViewer2
5 - Load model Molniya-Collision.edm
6 - Add model Moscow-Collision.edm
Result: both collision models will show correctly. (again, you will need to offset one of the models to see both)

7 - Close ModelViewer2 and Restart ModelViewer2

--->  Now, for the problem

8 - Load model Molniya.edm (DCS World OpenBeta/Bazar/World/Shapes)
9 - Add model Molniya-Collision.edm (DCS World OpenBeta/Bazar/World/Shapes)
Result: ModelViewer2 will abruptly quit.

The same model types work fine but adding a collision model to a loaded non-collision model results in ModelViewer2 crashing.  This used to work fine so I don't think my system is the issue.

 
Anyone else have this problem?

RustyGunner
 

[Flappie]

I cannot reproduce this issue in current OB (2.7.7.15038). Can you?

[RustyGunner]

Flappie,

Thanks for taking a look at my issue.  Updated to 2.7.7.15038 and still get the same results.  If I load the Molniya.edm model and then add the Molniya-collision.edm model,   ModelViewer2 will crash to desktop.  Attached is the Modelviewer2 log for this test case.  Hopefully, the log will help sort this issue out.  This happens whenever I try to add any collision model to a loaded basic model.

RustyGunner

 

model_viewer2 Log.txt

[Flappie]

My bad, I was doing it wrong. I'm now able to reproduce the crash using 'Add model' after 'Load model' with current OB.

I reported the issue. Thanks, mate.

[Flappie]

@RustyGunner Fixed in today's open beta 2.7.9.17830.