correct as is TMS lost effect on SOI TGP

[Rongor]

While fumbling around in the cockpit, I unsuccessfully tried to designate a random location in A-G mode with the HUD, which failed due to undocumented reasons. I got a SPI marker box and slew it to the left, visible in the HMCS. When designating didnt work, I tried again with the TGP, which caused the SPI marker to reset upon the first TDC input. I only had the TGP format in the MFD for this, didn't make it SOI.

After making TGP SOI at 04:04:00, I noticed that TMS inputs had no effect. Also creation of a Markpoint was impossible.
At 04:05:38 I am switching from Markpoint DED page back to CNI. Still no effect. Giving up.

trackfile below

OpenBeta 2.7.9.18080

NoTMSonTGPinCCRP.trk

[BIGNEWY]

Hi, 

you were in GUN STRF so the TGP was following the reticle, it probably confused the issue for you.

For making the mark point try

Switch to AG mode

make the HUD SOI

Turn on HMD make sure you are in VIS mode, ( you will see it in the HMD )

then use TMS up long press, this will make the HMD SOI

Go to MARK mode on the ICP / DED

then use TMS up short to ground stabilise the mark in the HMD

once ground stabilised TMS up short again and you will see the numbers from the mark go to the DED 

 

you should be good to go then, let me know if it helps