Assigning laser code to GBU-12

[Martik]

I’m having an issue assigning a code to by GBU-12.  The word “Code” is not appearing I’m the lower left corner of my stores page so I can’t enter the code.  I’m in A/G, my FLIR and laser are armed, but no code.  I’m following everything in the Chuck’s guide and Matt’s videos, but on my Hornet no “code”.  Any suggestions?

Many thanks!

[Drac]

Just to make sure, you have "master arm" on?

In SMS (Stores Management System) page, select GBUs
82 LG, boxed when selected

 

[pete_auau]

3 hours ago, Drac said:

Just to make sure, you have "master arm" on?

In SMS (Stores Management System) page, select GBUs
82 LG, boxed when selected

 

dont  need to have master  arm to on,  all you need  to  do is  to select  the  stores  page  and the  code  should  appear  on bottom  left  hand  crnr  and  the  gbu  on  top  left  hand  of  the ddi.

@Martikto the op  its  a strange  one  never  heard  of  this  before,  supposed  you have  tried  switching  to the  other  ddi,   restarting  dcs   etc my advice  is  to do  a  repair  of  dcs  or post it  in the  bug  section. 

Edit  just a thought  suppose  ed  hasnt  put  any  failures  in  etc  that we  havnt heard  of  yet

 

Edited March 6, 2022 by pete_auau

[Minsky]

Check if the hot gun is unboxed.

A/G, FLIR, master arm and whatnot don't matter.

[pete_auau]

43 minutes ago, Minsky said:

Check if the hot gun is unboxed.

A/G, FLIR, master arm and whatnot don't matter.

this  is  the  answer  forgot  about  the  gun selection