fixed George not turning on systems

[Rhinozherous]

Hello!

When i do a cold start I always start as pilot and when I am near the tgt zone I switch to the CPG seat and run the attack.

On switchover to the CPG seat George always left the TADS in off and has not boresighted the IHADSS (when turning on TADS it says "ihads boresight required" in the left down corner.

Switching on TADS is not that hard but boresighting IHADSS is annoying when setting up for attack.

Edited March 23, 2022 by Rhinozherous

[frostycab]

I think you can get him to turn on the TADS if you get him to cycle weapons when you're in the back seat.

[Rhinozherous]

5 minutes ago, frostycab said:

I think you can get him to turn on the TADS if you get him to cycle weapons when you're in the back seat.

Will trie this.

[frostycab]

As for boresighting, and since you're talking about cold start situations where you need to wait for the INUs, you could just hop into the front seat and boresight before takeoff and then switch back. It'll probably stay aligned. (Not tested to confirm)

[Rhinozherous]

4 hours ago, frostycab said:

As for boresighting, and since you're talking about cold start situations where you need to wait for the INUs, you could just hop into the front seat and boresight before takeoff and then switch back. It'll probably stay aligned. (Not tested to confirm)

Yes, but it would be nice if George does his job alone  Thats why I posted it in this section. But thank you for recommendations!