PhantomCat Posted July 17, 2022 Share Posted July 17, 2022 What is the nominal groove time for Case I recovery? Link to comment Share on other sites More sharing options...
Hitman-vCSG3 Posted October 18, 2022 Share Posted October 18, 2022 Our squadron encourages 14 seconds between carrier breaks for enough spacing. I haven’t seen numbers for groove time specifically. -Don 1 Link to comment Share on other sites More sharing options...
Thanatos31 Posted October 30, 2022 Share Posted October 30, 2022 I haven’t seen groove charts either, can only tell you that with the Airboss Script you get a “long groove time” rating if it’s above 60sec (iirc) - and I hope/ assumed that was entered by people that had some sources On 10/18/2022 at 4:32 AM, Hitman-vCSG3 said: Our squadron encourages 14 seconds between carrier breaks for enough spacing. I haven’t seen numbers for groove time specifically. -Don Same here, 14 sec breaks for separation during boat ops is SOP 1 Come fly with us : https://discord.gg/tawdcs TAW CJTF 13 - EU TZ MilSim Squadron Ryzen 5 5600X | 32GB DDR4 3733| ASUS Radeon RX 6700 XT | ASrock B550 Phantom Gaming 4 | HP Reverb G2 | Thrustmaster Warthog Throttle , F16 & F18 grips , TFRP Rudders | Win 10 Link to comment Share on other sites More sharing options...
Caldero Posted October 31, 2022 Share Posted October 31, 2022 I think the OP means how many time since nozzles in hover stop position to touch down in the boat Not sure but good figures are 3 - 4 min since "initial" to touch down Regards 1 Link to comment Share on other sites More sharing options...
PhantomCat Posted January 4, 2023 Author Share Posted January 4, 2023 Thank you for all the replies. Much appreciated. Link to comment Share on other sites More sharing options...
Thanatos31 Posted January 11, 2023 Share Posted January 11, 2023 Initial is 3nm off the boat on BRC. hope you don’t set your nozzles to hover stop already at that point Come fly with us : https://discord.gg/tawdcs TAW CJTF 13 - EU TZ MilSim Squadron Ryzen 5 5600X | 32GB DDR4 3733| ASUS Radeon RX 6700 XT | ASrock B550 Phantom Gaming 4 | HP Reverb G2 | Thrustmaster Warthog Throttle , F16 & F18 grips , TFRP Rudders | Win 10 Link to comment Share on other sites More sharing options...
A A ron Posted May 27, 2023 Share Posted May 27, 2023 On 7/17/2022 at 3:42 PM, PhantomCat said: What is the nominal groove time for Case I recovery? 15 to 18 seconds Link to comment Share on other sites More sharing options...
Nealius Posted August 7, 2023 Share Posted August 7, 2023 VMAT-203 syllabus references a groove distance rather than a groove time: 0.5~0.75nm, though some procedure descriptions prefer 0.5nm as "best." Somewhere I've heard "45 seconds" referenced but I don't have any sources. Link to comment Share on other sites More sharing options...
Recommended Posts