Schlomo1933 Posted January 28, 2023 Posted January 28, 2023 in the manual page 9-17 : • Input the aircraft’s known (parked) heading into the magnetic declination encoder using the adjustment lever; • Set the “MAN-GYRO-MH” (Manual Heading – Gyroscope – Magnetic Heading) switch on the right-side control panel to the “MAN” position, which will cause the HSI to turn to the true heading value (input value); -if you click the "man-gyro-mh" switch to manual with mouse , all is working -BUT if you switch to the "man" position with " Gyro/Mag/Man heading: NEXT" or "Gyro/Mag/Man heading: PREV" keybind , the HSI will NOT turn to the true heading value.
Flappie Posted April 23, 2023 Posted April 23, 2023 Issue reproduced and reported. Sorry for the delay. ---
Schlomo1933 Posted November 21, 2023 Author Posted November 21, 2023 (edited) Its not fixed ! Problem is still existing as i described in 1st post Edited November 21, 2023 by Schlomo1933
Flappie Posted November 22, 2023 Posted November 22, 2023 Are you using the latest OB? (2.9.1.48111) ---
Schlomo1933 Posted November 22, 2023 Author Posted November 22, 2023 (edited) Yes , iam To be more precise, I tested it with the key binds for :mag/ gyro/ man not with next/prev. I will test tomorrow if it will work with next/prev keybinds. Pls, change the status Edited November 22, 2023 by Schlomo1933
Flappie Posted November 22, 2023 Posted November 22, 2023 4 minutes ago, Schlomo1933 said: Pls, change the status Allow me to reproduce the issue first. ---
Schlomo1933 Posted November 22, 2023 Author Posted November 22, 2023 (edited) I updated my last post with some more specific information Edited November 22, 2023 by Schlomo1933 1
Flappie Posted November 22, 2023 Posted November 22, 2023 This is all I have for the Ka-50 III when looking for "mag". What you see below in green works for me. It was not working before, and this is what I had reported when I read this thread, and this is what is now fixed (at least for me) in OB. * If you're seeing some other "mag" controls, please post a screenshot. ---
Schlomo1933 Posted November 22, 2023 Author Posted November 22, 2023 Yes , will try this tomorrow. I use the community keybinds , and there just the switch is moving but not the hsi when u adjust the heading .
Schlomo1933 Posted November 23, 2023 Author Posted November 23, 2023 (edited) with the DCS standard keybinds this is working Flappie but switch up/down it’s a terrible solution for cockpit builders …. We need also the switch working with the “munkwolfs community keybinds” (One switch position for mag, one for gyro and one for manual heading) the community keybinds are giving those to us. Unfortunately they are not working with the HSI Edited November 23, 2023 by Schlomo1933 1
Recommended Posts