Jump to content

Bomb spacing ?


Go to solution Solved by kontiuka,

Recommended Posts

Posted (edited)

When you drop bombs you can can set the weapon system to single or salvo.

When you are in salvo, can you set the bomb spacing interval ?

I didn't find any way...

 

Edited by jojo

Mirage fanatic !

I7-7700K/ MSI RTX3080/ RAM 64 Go/ SSD / TM Hornet stick-Virpil WarBRD + Virpil CM3 Throttle + MFG Crosswind + Reverb G2.

Flickr gallery: https://www.flickr.com/gp/71068385@N02/728Hbi

  • Solution
Posted (edited)
3 hours ago, jojo said:

When you drop bombs...

No way to set it.  You would just have to control spacing with speed and dive angle and release altitude.

Edited by kontiuka
Posted (edited)

The Mirage III Timing/spacing was 0.3 seconds (300milliseconds). Cant find a specific reference for the F1. However switcholgy in the F1 is the same.

Knowing the bomb intervelometer spacing then using the chart below you can figure the bomb spacing.

LDbombspacing.jpg

Edited by IvanK
  • Thanks 2
Posted

Not sure what bomb you are using, but I have found that using any chute retarded bombs, single release with button press with the start of a 3 syllable word. 

Eleven, eleven, eleven with the press on the start of each word. 

Posted
2 hours ago, Snacko 2-1 said:

Not sure what bomb you are using, but I have found that using any chute retarded bombs, single release with button press with the start of a 3 syllable word. 

Eleven, eleven, eleven with the press on the start of each word. 

Why not use SALVO with single button press and hold ?

Posted
16 hours ago, IvanK said:

Why not use SALVO with single button press and hold ?

Because more math is involved to know the spacing. 

 

Single release with multiple button presses allows me to control the spacing without the math. 

Posted

Hi guys!

As it was said before, there is no way to control the release timing in salvo mode in the CE, EE and BE. In these models, the delay is always 180 ms and the spacing is controlled through the velocity at release. The M has the option to select different timings through the MFD.

  • Like 1
  • Thanks 2
Posted
59 minutes ago, fausete said:

Hi guys!

As it was said before, there is no way to control the release timing in salvo mode in the CE, EE and BE. In these models, the delay is always 180 ms and the spacing is controlled through the velocity at release. The M has the option to select different timings through the MFD.

Thanks

  • Like 1

Mirage fanatic !

I7-7700K/ MSI RTX3080/ RAM 64 Go/ SSD / TM Hornet stick-Virpil WarBRD + Virpil CM3 Throttle + MFG Crosswind + Reverb G2.

Flickr gallery: https://www.flickr.com/gp/71068385@N02/728Hbi

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...