Jump to content

When switching MRM / DGFT override, the current radar mode is dropped and RWS becomes active


Recommended Posts

Posted

When you select TWS in MRM override, the radar defaults back to RWS when cycling the OVRD switch.
After a mode change, it will always fall back to RWS, the current mode isn't stored.
Each submode should remember its radar setting.

Steps to reproduce: Select MRM with the override switch, select TWS with TMS right long, cancel override, enter MRM override again. Radar will default to RWS.

  • Like 1
Posted (edited)

After DCS 2.9.5.55300
When you select DOG FIGHT (Missile Override) mode on the throttle. The system does not save the radar settings. It also skips selecting ACM mode. Exiting DOG FIGHT mode and returning to it again causes, in addition to forgetting the ACM mode, also random selection of the "radar bar mode". Even "A0"??? This is an obvious mistake.

Not to mention the fact that the DOG FIGHT mode on the throttle works badly from the beginning. This mode, both in the "outboard" + gun position and in the "inboard" position without gun + situational awareness guidance, should activate the radar in ACM mode by default. To select RWS / TWS modes, "master mode AA" is used. Unfortunately, I cannot provide the source of this information, which would confirm the operating modes of this system in F16.

Finally, I am asking you to repair the memory of the DOG FIGHT mode and look into the problem of proper operation of this mode.

Regards

ACM bug.trk

Edited by 318_Bonzo
  • Like 2
  • 318_Bonzo changed the title to DOG FIGHT Switch - does not remember settings / random bar mode.
Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...