Raffi75 Posted Monday at 06:46 PM Posted Monday at 06:46 PM At what point do you turn on the anti-icing system and pitot tube heater? I always do this on the ground, before turning off the AI-9, and I have no problems during flight. I checked the manual today; the anti-icing system and pitot tube heater turn on at temperatures of +5°C and below.
Raven (Elysian Angel) Posted Monday at 06:59 PM Posted Monday at 06:59 PM 11 minutes ago, Raffi75 said: At what point do you turn on the anti-icing system and pitot tube heater? I always do this on the ground, before turning off the AI-9, and I have no problems during flight. I checked the manual today; the anti-icing system and pitot tube heater turn on at temperatures of +5°C and below. I normally turn them on on the ground too, and never had problems with it before this mission. Because it did give me problems the first time around, I decided to turn them on immediately after gear up, and that’s when I lose an engine. I’ll try one last time tomorrow, but frankly this is getting annoying Spoiler Ryzen 7 9800X3D | 96GB G.Skill Ripjaws M5 Neo DDR5-6000 | Asus ProArt RTX 4080 Super | ASUS ROG Strix X870E-E GAMING | Samsung 990Pro 2TB + 990Pro 4TB NMVe | VR: Varjo Aero VPC MT-50CM2 grip on VPForce Rhino with Z-curve extension | VPC CM3 throttle | VPC CP2 + 3 | FSSB R3L | VPC Rotor TCS Plus base with SharKa-50 grip | Everything mounted on Monstertech MFC-1 | VPC R1-Falcon pedals with damper | Pro Flight Trainer Puma OpenXR | PD 1.0 | 100% render resolution | DCS graphics settings Win11 Pro 24H2 - VBS/HAGS/Game Mode ON
Raffi75 Posted Monday at 07:07 PM Posted Monday at 07:07 PM This is a bit strange. I only had one icing problem this campaign, but it was clearly my fault because I hadn't turned on the pitot tube heater. I turned it on in flight, and after a while, everything was fine.
Raven (Elysian Angel) Posted Monday at 07:19 PM Posted Monday at 07:19 PM Yes, it’s as if the generators can’t provide enough voltage/current for all systems if I turn on anti ice on the ground. The electrical panel has the green light indicating the generators are active, yet the autopilot/dampers refuse to stay on. It’s why I even tried to keep the APU running and turned on the APU generator for good measure, but it didn’t help. Spoiler Ryzen 7 9800X3D | 96GB G.Skill Ripjaws M5 Neo DDR5-6000 | Asus ProArt RTX 4080 Super | ASUS ROG Strix X870E-E GAMING | Samsung 990Pro 2TB + 990Pro 4TB NMVe | VR: Varjo Aero VPC MT-50CM2 grip on VPForce Rhino with Z-curve extension | VPC CM3 throttle | VPC CP2 + 3 | FSSB R3L | VPC Rotor TCS Plus base with SharKa-50 grip | Everything mounted on Monstertech MFC-1 | VPC R1-Falcon pedals with damper | Pro Flight Trainer Puma OpenXR | PD 1.0 | 100% render resolution | DCS graphics settings Win11 Pro 24H2 - VBS/HAGS/Game Mode ON
Raffi75 Posted Monday at 09:31 PM Posted Monday at 09:31 PM (edited) 2 hours ago, Raven (Elysian Angel) said: Yes, it’s as if the generators can’t provide enough voltage/current for all systems if I turn on anti ice on the ground. The electrical panel has the green light indicating the generators are active, yet the autopilot/dampers refuse to stay on. It’s why I even tried to keep the APU running and turned on the APU generator for good measure, but it didn’t help. Can you send me the tack file? Mission 10: I managed to complete it successfully. Today was a bit different than the first attempt at the mission. When the Volk-2 taxied very close to my tail after stopping on the taxiway, it stopped, waited a moment, and then took off vertically. It continued its mission independently for the rest of the mission. It immediately flew from the airport into the mountains. The Oriol-1 froze in a hover again. This time, I didn't have the colored (yellow) message about the troops being loaded, nor the information to select the cargo. After landing and selecting the report, there was no document animation, but the typewriter sound was there. Despite these minor glitches, the mission ran smoothly. I enjoyed it. Edited Monday at 10:17 PM by Raffi75
Raven (Elysian Angel) Posted Monday at 09:56 PM Posted Monday at 09:56 PM 24 minutes ago, Raffi75 said: Can you send me the tack file? I have track files disabled. I’ll see what happens tomorrow… 1 Spoiler Ryzen 7 9800X3D | 96GB G.Skill Ripjaws M5 Neo DDR5-6000 | Asus ProArt RTX 4080 Super | ASUS ROG Strix X870E-E GAMING | Samsung 990Pro 2TB + 990Pro 4TB NMVe | VR: Varjo Aero VPC MT-50CM2 grip on VPForce Rhino with Z-curve extension | VPC CM3 throttle | VPC CP2 + 3 | FSSB R3L | VPC Rotor TCS Plus base with SharKa-50 grip | Everything mounted on Monstertech MFC-1 | VPC R1-Falcon pedals with damper | Pro Flight Trainer Puma OpenXR | PD 1.0 | 100% render resolution | DCS graphics settings Win11 Pro 24H2 - VBS/HAGS/Game Mode ON
dggoofy Posted Tuesday at 06:52 AM Author Posted Tuesday at 06:52 AM On 8/3/2025 at 2:07 PM, Raffi75 said: Mission 5: On my first attempt, I completed a night flight along the route. Takeoff and landing were successful, and nothing happened along the way. Only on my second attempt did everything go according to plan. Mission 9: I attempted this mission several times (my life). Volk 3 took off vertically from the stand. On my second attempt, Volk 2, 3, and 4 took off vertically before the colonel boarded and circled the airfield. Later, they joined me, and I was able to continue the mission. On my last, successful attempt, Volk 4 took off vertically before entering the runway. It's an issue with DCS : AI helos takeoff are unreliable. I've had the same problems! Sometimes, all aircraft take off normally from the runway, but other times, the AI just goes completely wild. I’ve sent a message to ED (Eagle Dynamics) so they can fix this issue. 1 2
Raffi75 Posted Wednesday at 02:55 PM Posted Wednesday at 02:55 PM (edited) Mission 11: I don't know why I have a map from mission 10 in my kneepboard and the reconnaissance photos are missing. The same thing happens in mission 12. I checked the campaign files. I'm comparing it to the PDF document that came with the campaign. Edited Wednesday at 03:02 PM by Raffi75
Raven (Elysian Angel) Posted Wednesday at 07:26 PM Posted Wednesday at 07:26 PM I managed to get past Mission 4 without generator/anti-ice problems Spoiler But I forgot to rearm to the loadout mentioned by the briefing, and I had some leftover infantry after I depleted my rockets so I had to use my 30mm to take them out. A door gunner would indeed have been a lot better Spoiler Ryzen 7 9800X3D | 96GB G.Skill Ripjaws M5 Neo DDR5-6000 | Asus ProArt RTX 4080 Super | ASUS ROG Strix X870E-E GAMING | Samsung 990Pro 2TB + 990Pro 4TB NMVe | VR: Varjo Aero VPC MT-50CM2 grip on VPForce Rhino with Z-curve extension | VPC CM3 throttle | VPC CP2 + 3 | FSSB R3L | VPC Rotor TCS Plus base with SharKa-50 grip | Everything mounted on Monstertech MFC-1 | VPC R1-Falcon pedals with damper | Pro Flight Trainer Puma OpenXR | PD 1.0 | 100% render resolution | DCS graphics settings Win11 Pro 24H2 - VBS/HAGS/Game Mode ON
dggoofy Posted 21 hours ago Author Posted 21 hours ago 16 hours ago, Raffi75 said: Mission 11: I don't know why I have a map from mission 10 in my kneepboard and the reconnaissance photos are missing. The same thing happens in mission 12. I checked the campaign files. I'm comparing it to the PDF document that came with the campaign. Damned! You're right. My bad. I fix this issue and upload right now an update. Sorry. 1
Raffi75 Posted 16 hours ago Posted 16 hours ago These are minor issues that could easily be improved. The most important thing is that the mission was successful without any hiccups. 1
Sobakopes Posted 12 hours ago Posted 12 hours ago (edited) I need advice on wingman taxiing and disappearing on taxi runway at start. Mission 6 i ve done without wingman. But he appeared in the air when i landed in strip in the end after the 'vampire 1 rolling (for takeoff)' message appeared (when i was in fact rolling after landing having done all objectives. Edited 10 hours ago by Sobakopes
Raffi75 Posted 9 hours ago Posted 9 hours ago I was going to write about this tomorrow, after finishing the entire campaign, but since the topic is already on the table, I'll write a few words today. One thing that doesn't quite work as expected is the AI wingman's behavior. I noticed during the campaign that the AIs could take off on their own, at different times and in different places, and disappear from the airport while taxiing. Later, they would reappear in the air and perform their tasks. I suspect these are errors related to the DCS itself, not specifically related to the campaign. dggoofy also mentioned this. Despite this AI behavior, the missions themselves ran smoothly and were consistent. Well, maybe except for the first attempt at mission no. 5, where I had a night tour of the Afghan skies because nothing happened. The second time, everything worked fine.
Raven (Elysian Angel) Posted 9 hours ago Posted 9 hours ago Mission 5: Spoiler Just did what ended up being my first attempt, as I was shredded to pieces by the 2nd ZUU-23 (at least I know where it is now! ). Oh and as a general hint to make night missions and "city glow" look better: personally I increase gamma to 2.8 for such missions (from the default 2.2): it is dark enough to be realistic and bright enough to be able to just about make out other helicopters if you know where to look... And it doesn't completely wash out cockpit lighting But it is something ED really should improve (night lighting in general), along with the ridiculous accuracy of Mk1- eyeball guided AAA 2 hours ago, Sobakopes said: I need advice on wingman taxiing and disappearing on taxi runway at start. That's not something campaign makers have a lot of influence over, really. They can try to mitigate some of the issues with AI through clever use of waypoint special commands etc, but in the end it's up to ED to fix. Spoiler Ryzen 7 9800X3D | 96GB G.Skill Ripjaws M5 Neo DDR5-6000 | Asus ProArt RTX 4080 Super | ASUS ROG Strix X870E-E GAMING | Samsung 990Pro 2TB + 990Pro 4TB NMVe | VR: Varjo Aero VPC MT-50CM2 grip on VPForce Rhino with Z-curve extension | VPC CM3 throttle | VPC CP2 + 3 | FSSB R3L | VPC Rotor TCS Plus base with SharKa-50 grip | Everything mounted on Monstertech MFC-1 | VPC R1-Falcon pedals with damper | Pro Flight Trainer Puma OpenXR | PD 1.0 | 100% render resolution | DCS graphics settings Win11 Pro 24H2 - VBS/HAGS/Game Mode ON
Recommended Posts