-
Posts
30 -
Joined
-
Last visited
-
Hello, I need your help please. I installed slew upgrade without issue however the plug for the axis did come out, i popped it back in. i have run the calibration utility but the range of axis on both throttles is very limited.and also reversed? if i run the windows calibration which i know you are not meant to do i get the full range again but the slew jumps around.
can you advise if at all possible.
thanks
Clive
-
Hi Clive,
Sorry to hear that.
That problem is usually caused by something going wrong during the calibration.Please try to calibrate the throttle again using the tool downloaded from my website. But be careful to move the throttle to the OFF, IDLE and MAX positions when asked.
Off is the fully back position over the detent lifts, IDLE is the next stop up or the minimum flight setting, and Max is the fully forward position over any afterburner detents.If you have any custom detents or afterburner lifts installed, you might need to remove them temporarily for the calibration.
You may also need to clear the Windows calibration again by going to:
Set up USB game controller >> Throttle HOTAS Warthog >> Settings >> Reset to Default >> Apply >>OKI hope that helps, let me know how you get on.
-
Thank you so very much, i was convinced i had done something wrong. i can confirm i am an idiot.
i was not pulling the stick past the detents convinced in my head they were buttons and not part of the axis.
all working now and i cannot tell you how relieved I am, thought I was going to have to tell the missus I needed a new throttle
thanks again
Clive
-