Killg0re NL

Module : F-16C Training : Lesson 9 - Air-Air ACM and HMCS Filename : Lesson 14 - Air-AIR ACM and HMCS Use.miz (better would be Lesson 9 - Air-AIR ACM and HMCS Use.miz) Triggers: Cockpit Setup 1 C OSB1..., Should be OSB 1... Triggers: Cockpit Setup 1 D OSB19, Should be OSB 19 Triggers: Cockpit Setup 1 E OSB2, Should be OSB 2

Module : F-16C Training : Lesson 8 - AIM120 using TWS & LINK-16 Filename : Lesson 13 - Air-Air TWS and LINK-16 use.miz (Better would be: Lesson 8 - Air-Air TWS and LINK-16 use.miz) Triggers: Cockpit Set 1C OSB2, Should be OSB 2

Module : F-16C Training : Lesson 7 - AIM120 B & C Air-Air Missiles Filename : Lesson 12 - AIM120 BC Air-Air Missles.miz (better is: Lesson 7 - Aim120 BC Air-Air Missiles.miz) Triggers: Intro MESSAGE TO ALL: SPACE bar, should be SPACEBAR. Triggers: Ready to Go Run 3 MESSAGE TO ALL: intercpt, should be intercept MESSAGE TO ALL: SPACE bar, should be SPACEBAR.

I barely have the guts to paste my results in, as what i see you made... I made my own F16 Throttle to USB adapter what i had laying arround. I will have to wait till the USB chassis connector is in.

i started a new DCS session so i could play DCS. Clearified 1st post.

Was anyone able to fit this on the Virpil collective lever, by means off altering this design, or make an adapter for it? And perhaps someone made a PCB for this also?

Yesterday i did a Motherboard (MSI B450) bios update, (The update has updated AMI USB drivers, a thingy with AMD atm) I had this earlier, but now i could connect this to the Bios update. Might it have to do with the PC vingerprint of PC, missing the login credentials , and if it goes wrong in the login procedure. Below is described what i'fe done: Did Motherboard BIOS update Then i started DCS, but did not enter the credentials when i was asked for (as i did not now them att) Got a messgae about the not available modules. Found out i could not do what i wanted to (Just check they keybinds) Started DCS for second time Then did enter the Credentials i was able to check the control's When i had time to play again, and fly the KA-50, my cockpit labels where in Russian. (Startrd DCS in the evening again , 3rd time)

On request off TS, i post my skill's here. Buttonbox, mainly for Simracing, but adapted to Flightsimming, it is acting as an keyboard, so it uses default DCS keybinds. ie with the dials i can change radio frequency's, and with buttons offcourse 'toggle' ingame buttons Engine start, does the Auto Start Sequence, the red ring, is the Auto Shutdown Sequence With one push off the Blue (eFunc) button i can let the rotating knobs do something else. The Led positions where let out, but where allready drilled, so i'f figure a way to have them usable aswell. And again GJ on the hardware module's

posted on the YT channel, but post did not make it. For the VR use, might it be an option, to have keybinds? So when you are on the MAP in VR, and press the keybind/controller input, TheWay does the magic in the background. Another option might be OVRTools, but not quite famliar with that. (Shows custom window, in VR Screen)