hreich

Same situation here..two kids, when they fall asleep, i a looking at 2200... Just dont have time to fly 1+ hour mission..Also i dont know if other have problem, but saving track record just doesnt work...When i replay track, plane just fly his own agenda

yep, i did the same with notepad++..Bu when i use firstmision.bat, it closes fast so i cant read text, and the first mission generated is cap. After that i try to repeat the procedure, bit i see that existing mission.miz file isn't changed - do i have to delete it first, and then run firstmission.bat again?

Tomcats over PG

Yes i also would like to knwo that,and also are new jester radar commands for range while scan added also?

I started again the campaign, fist mission was CAP, i accepted result, the next one was CAS mission but it put me in the hornet?

I seem to have problem..Manually generating new misison for f14 always give ma cap, although i changed aa_oob settings in folder "init" and folder "status", and also disabled cap for F-14B. Looks like the first mission.bat doennt change the first mission file, although it reports that new mission is generated..No error..Please tell me what am i doing wrong? Its aways the same cap mission, with same mission parameters, start time etc...

Are also new rio commands for radar rws going to be implemented in new patch?

[bUG] IFLOLS/meatball indicator moved to the right screen When i have two monitors enabled, my IFLOLS/meatball indicator is always moved to the right screen...How can i move it to the left screen, but keep it on right side?

Can i have my surname Reich on the front ckp T? Sent from my Redmi Note 4 using Tapatalk

When using 2 screen setup, landing grade box when enableing control position indicator is moved to the second screen..Dows anybody know how to move it to left screen?

I ask because i never get the grade, nor the checkmark on wire number that i catch?

I am using 2 screen setup 1920x1080 ..When enabling control position indicator, the green/yellow/red square is moved to the right screen, and control position indicator is on the left screen.

How to add crank L/R engine off switch?

I have two monitors, and managed to move kneeboard to my left screen...But when using control position indicator, it's moved to the right screen...How can i move it to the right side of my left screen?

Thanks, pilot cant setup datalink from his cockpit?

...so i can get the green yellow red box in right corner with r_ctrl+ent combo?

Ok.thanks that clears it for me..

Cant find it in manual...

I didnt trim..and was connected to cat...just didn’t have positive rate of climb...

Ok thanks

Keep up the good work!

I have two screen setup 1920x1080 2x monitors...Jester UI is centered between two monitors, kneeboard is on the right monitor... I assume that NVG is also right in the middle of both screens... How can i reposition them to be visible only on first screen?

Yep just noticed after downloading F14

... How about yourd?

Where do you press F5?