Jump to content

Recommended Posts

Posted
Whenever there is a conditional "set failure" trigger in the mission, the failure will occur even if the condition is not met. See the attached mission. It should only happen when the player select the F10 radio menu. Yet the hydraulics fail after a couple of seconds anyhow.

 

Hi,

 

Seems to me like a bug of the F-14 module rather than the trigger .. the first time that I run the mission it works as intended.

 

Once I've used the F10 command and induced the Hydraulic Failure, then if I wait until the aircraft loses electric power, then F-14 module seems to not clear-up its status, so if I restart the mission it will have the Failure already ON, even if I return to the Editor and then run the mission again, the Failure is still ON.

 

If I restart the mission before the aircraft loses power, then the above situation doesn't occur and I can fly fine until I induce the failure with the F10 option.

 

If I close DCS and start it again, then the Failure will have cleared and the mission will run fine.

 

Perhaps you should post this Bug on the Tomcat forum.

Cheers,

 

For work: iMac mid-2010 of 27" - Core i7 870 - 6 GB DDR3 1333 MHz - ATI HD5670 - SSD 256 GB - HDD 2 TB - macOS High Sierra

For Gaming: 34" Monitor - Ryzen 3600 - 32 GB DDR4 2400 - nVidia RTX2080 - SSD 1.25 TB - HDD 10 TB - Win10 Pro - TM HOTAS Cougar

Mobile: iPad Pro 12.9" of 256 GB

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...