Jump to content

Recommended Posts

Posted

Hello good night I need help for the next problem. When I want to take off with the 10 c from Indian Spring in Nttr scene I do not get enough speed and I leave the track. The trottle is at maximum and reaches only 117 knots and the airplane takes 70% of fuel and few weapons.What is trottle problem? Any help will be welcome

Posted
Also, throttle up with the brakes on and release at full power, take off flaps down at 100 knots, and rotate at 110.

 

Well sort of.

 

Flaps MVR should be set before entering the runway. If the runway is too short to have their drag all the way during the takeoff roll, then I simply wouldn't take off from that runway. :smartass:

 

IIRC, rotation speed depends on weight and drag. "110" might work well for one loadout, and quite terribly for another. To play it safe, I'd suggest something like 130 or more with a typical combat loadout and full gas. Again, if takeoff speed can't be achieved before the end of the runway, I just wouldn't take off there (plus it's always nice to have some runway remaining in case of engine failure...).

Posted
Runway 13/31 is for UAS (Predator/Reaper) only. Try taking off from Runway 10/28 instead.

 

That's a good point. Creech AFB is a base where they are operating a lot of UAVs.

[sIGPIC][/sIGPIC]

Posted

I tested it in Nellis AFB with the a 10 c and the result was the same.The Max velo city was 123 knots and craso out of the run way.i think i need curves to set my throttle

Posted
I tested it in Nellis AFB with the a 10 c and the result was the same.The Max velo city was 123 knots and craso out of the run way.i think i need curves to set my throttle

 

Wow. The runway is some 10,000 ft long. It's pretty much impossible to run out of runway there. Hell, you could get airborne on one engine with a full weapons load and haul your wingman's hog on a rope if need be... :D

 

Please upload a track.

 

As a very wild guess, can you double check that your wheelbrakes are off when you start your takeoff roll?

Posted

Open the Controls Indicator overlay; by default, that's RCTL+Enter.

 

Wiggle or toggle the wheelbrakes a few times. When the brakes are on, you should see red bars on the left and right side; with the brakes off, these bars disappear.

Posted

thanks so much Yurgon

I have solve it; I have opened controls indicator and i have seen that wheelbrake are a few on then i have put it to zero and all is ok.

Thanks again

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...