[NO BUG] Cold Start Training Mission - FCS BIT Test

[SnapRoll]

It says to press the FCS BIT test button on the right DDI while simultaneously holding the FCS BIT Test switch on the right wall in the on position.

I’ve noticed it works just as well if you first press the DDI button and then the FCS BIT Test switch on the right wall. One after the other, not at the same time (mouse).

 

Don’t know if it is supposed to work like this…

[Eldur]

Seen this as well after doing so accidently.

[Jack McCoy]

FCS BIT Test switch runs the controls routine even without the DDI-FCS-BIT press. I haven't tested if the FCS-BIT actually succeeds (FCSA:Go / FCSB:Go) in this case.

[flyingscotsman]

Thanks for this thread. My problem is I cannot do both at once as suggested, So I've been stuck. Will do it in the sequence given. although I think I tried that. thanks

[Crew Dog]

Thanks for this thread. My problem is I cannot do both at once as suggested, So I've been stuck. Will do it in the sequence given. although I think I tried that. thanks

 

Easiest way it s hold the Y key while pressing OSB 20 when in the FCS BIT page

[flyingscotsman]