Jump to content

Recommended Posts

Posted

I didn't want to hijack another thread on this topic. So basically I can't really make out the ball until 1/2 to 3/4 of a mile without zooming in, is that normal?. I adjusted my gamma to 1.6. My screen res is 1680x1050, 32" monitor.

Posted

Yup, same here. 2k resolution.

Would be nice to have a little "cheat" overlay which you can enable like the controls overlay (ctrl+enter) which shows you the ball.

Posted

Would be nice to have a little "cheat" overlay which you can enable like the controls overlay (ctrl+enter) which shows you the ball.

 

 

+1,000,000,000,000.00

AWAITING ED NEW DAMAGE MODEL IMPLEMENTATION FOR WW2 BIRDS

 

Fat T is above, thin T is below. Long T is faster, Short T is slower. Open triangle is AWACS, closed triangle is your own sensors. Double dash is friendly, Single dash is enemy. Circle is friendly. Strobe is jammer. Strobe to dash is under 35 km. HDD is 7 times range key. Radar to 160 km, IRST to 10 km. Stay low, but never slow.

Posted (edited)

I play on 4K and it's still hard to see, or mostly impossible without a lot of zoom. So it's not going to be improved by upping resolution to anything currently practical.

 

Also, inb4 'But you should only be in the groove at max 3/4 mile only anyway, so no worries' :D

 

Some nostalgia: Jane's F18 from the year 2000 had a zoomed in IFLOLS view in a separate window when in the groove:

 

fa18-10.jpg

Edited by ARM505
Posted

Yep, I have been using zoom as well. It makes it a little more touchy. Played around with different graphic settings as well.

Posted
Yup, same here. 2k resolution.

Would be nice to have a little "cheat" overlay which you can enable like the controls overlay (ctrl+enter) which shows you the ball.

Yes, a small overlay window would greatly help. Am on 1920x1080p resolution and I get to spot the ball when close to the deck end and at this point I almost cannot apply any control input.

I more or less do not use the ball in all my successful carrier landing.

If I have to zoom in, data symbols on the HUD would be out of view.

Windows 10 Pro 64bit|Ryzen 5600 @3.8Ghz|EVGA RTX 3070 XC3 Ultra|Corair vengence 32G DDR4 @3200mhz|MSI B550|Thrustmaster Flightstick| Virpil CM3 Throttle| Thrustmaster TFRP Rudder Pedal /Samsung Odyssey Plus Headset

Posted
Yes, a small overlay window would greatly help. Am on 1920x1080p resolution and I get to spot the ball when close to the deck end and at this point I almost cannot apply any control input.

I more or less do not use the ball in all my successful carrier landing.

If I have to zoom in, data symbols on the HUD would be out of view.

 

I just try to focus on centerline, ball and AOA indexer - continual scan.

Posted

If overlay should be implemented, I suggest it has the limits in the navy video circa 1950s. No point in having FLOLS if you can see it above limits.

AWAITING ED NEW DAMAGE MODEL IMPLEMENTATION FOR WW2 BIRDS

 

Fat T is above, thin T is below. Long T is faster, Short T is slower. Open triangle is AWACS, closed triangle is your own sensors. Double dash is friendly, Single dash is enemy. Circle is friendly. Strobe is jammer. Strobe to dash is under 35 km. HDD is 7 times range key. Radar to 160 km, IRST to 10 km. Stay low, but never slow.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...