skywalker22 Posted August 21, 2019 Posted August 21, 2019 Hi there, I`m pretty new to DCS, so far I only fly with Su-27, but lately I started to play with details, and one of them was the HUD stuff, like moving radar to seek for the targets), and manually setting radar scan for correct aiming of the target. But I think I have found some glitch in the order of the commands. I think that the commands for Scan Zone Up/Down and Predicted Target Range Decrease/Increase are swapped. If I swap them seems all works fine, I can move the bar on the HUD (middle right side) for the Vertical Radar Movement, and I can set the number (from -15 to +15) just next to that bar. -- Previously when I have set buttons I wanted for Scan Zone Up/Down, it was changing both (bar and the number at same time - which is surely NOT OK in my opinion; we want to move them independently). What do you think, am I right? -- Commands for Scan Zones Left and Right are OK command for Target Specified Size Decrease/Increase are OK (horizontal manual setting the distance - number at the bottom center) Which all work together.
draconus Posted August 21, 2019 Posted August 21, 2019 (edited) Works OK for me - nothing is swapped. The bar and number for vertical radar scan zone are bound together and it's correct. Two marks follow your nose position to show you the area covered by your HUD in relation to the radar vertical scan area. Edited August 22, 2019 by draconus Win10 i7-10700KF 32GB RTX4070S Quest 3 T16000M VPC CDT-VMAX TFRP FC3 F-14A/B F-15E CA SC NTTR PG Syria
skywalker22 Posted August 22, 2019 Author Posted August 22, 2019 (edited) So is it correct that the bar and the number for vertical scan are bound together? Sorry, but to my logic, would be more logical, to set both seperatelly. Bar for scanning and the number for manual setting of the altitude. -- So by your words, to move the antenna I only have to use commands of Scan Zone. What does then mean: 1. Predicted Target Range Decrease/Increase 2. Target Specified Size Decrease/Increase Edited August 22, 2019 by mitja_bonca
draconus Posted August 22, 2019 Posted August 22, 2019 (edited) 1. https://forums.eagle.ru/showthread.php?p=3271042 Post #3 explains it. 2. Used in gun funnel mode (when no lock and cannot get the range from sensors) - sets the predicted target wing span to have better aiming cue. Edited August 22, 2019 by draconus Win10 i7-10700KF 32GB RTX4070S Quest 3 T16000M VPC CDT-VMAX TFRP FC3 F-14A/B F-15E CA SC NTTR PG Syria
skywalker22 Posted August 22, 2019 Author Posted August 22, 2019 Thank you, so I was wrong. Commands are all fine.
pepin1234 Posted August 22, 2019 Posted August 22, 2019 You have this problem with the keyboard input, or with your Joystick? [sIGPIC][/sIGPIC]
skywalker22 Posted August 22, 2019 Author Posted August 22, 2019 No, nothing to do with the controls, but I thought it game`˙s issue, but it actually isn`t. Let forget about it.
Recommended Posts