Prophet_f15 Posted April 25, 2020 Posted April 25, 2020 I tried setting the AIM-9 from Slave to Bore via the enable switch (assigned by Joystick) but it does the same as the uncage switch. The Cursor/Enable Switch is the Enable Switch, isn't it?
mkiii Posted May 24, 2020 Posted May 24, 2020 I'm using Open-Beta so may differ in setup, but the Uncage Switch ©, and the Enable Switch (ENTER) do seem to be doing the same thing here too. I think the Uncage button may operating incorrectly, it's hard to tell, since it seems not to function unless a target is in view!?. The Enable switch seems to function as it should - setting Bore/Slave modes. It isn't working asw it does in "other sims" - but they could be wrong. TBH, I'm avoiding the F-16 right now - it is too incomplete, and the ESC menu has stopped working with it for me.
fudabidu Posted August 28, 2020 Posted August 28, 2020 Go into control options and press ESC. If it doesn't show you the binding then you deleted it by accident. :D
SCPanda Posted September 1, 2020 Posted September 1, 2020 Yeah all the WIP functions and "incorrect" HOTAS commands are not helping, and even worse they make you form up bad habits.
Frederf Posted September 1, 2020 Posted September 1, 2020 Holding enable should switch AIM-9 to the other mode than is set (bore/slave). AIM-9 uncage has threshold detect circuitry which inhibits uncaging without good signal. If TD/BP is set BP then circuitry is bypassed.
Sprool Posted November 12, 2020 Posted November 12, 2020 I was wondering what the Enable switch - depress was, on the throttle grip, Hotas, or what it should be.
Frederf Posted November 13, 2020 Posted November 13, 2020 Enable is the name of the function when you push inward the cursor control. The combined control of the cursor X-Y axes and enable button is often called "cursor enable".
Sprool Posted November 13, 2020 Posted November 13, 2020 So is it only relevant to the Aim-9 for bore/slave mode at the moment?
Recommended Posts