Funny Harmless story :)

[macedk]

Hi all :)

 

So like so many others, I loaded my harms and had a sam site at WP1.

 

Had Wagner's video up, to back me up.

 

Harm page is on and all is powered up.

 

Flying to waypoint one, getting close....

 

Nothing on the harm page ???

 

Now over the waypoint and raw goes off with a tracking sound and 4 seconds later dead ??

 

Hmm what went wrong here...hmm thinking...

 

The genius that I am, I loaded a sa-13 which is electrical optical tracking system.

 

Haven't tested the harm since....tough pill to swallow ;)

 

Thank god it is just a simulation hahaha :)

[Eaglewings]

Did you select the threat table that matches the sa-13 detection profile?

[BIGNEWY]

Hi

 

SAM probably started in a green alert status, try with them set to RED alert status.

 

:)

[macedk]

Hi

 

SAM probably started in a green alert status, try with them set to RED alert status.

 

:)

 

Thanks :)

 

Yeah I started like 50 nm from it.

 

I'll go try that :)

[macedk]

I place a single sa-13 in red state and fly over after 4 minutes. Sa-13 engages at roughly 2 nm before i overfly it. I don't get any indication on the harm display.

 

I will try sending an ai into the threat zone and see if it shows up on my harm display.

[Tholozor]

The radar on the SA-13 is to provide range-only data to the operator, the launcher itself is aimed manually. It's possible to get a HARM off on it, but the launcher isn't likely to use its radar until you're close enough for it to spot you visually.

[macedk]

The radar on the SA-13 is to provide range-only data to the operator, the launcher itself is aimed manually. It's possible to get a HARM off on it, but the launcher isn't likely to use its radar until you're close enough for it to spot you visually.

 

ok :)

 

Thanks :)