TAKT doesn't output 900000 when holding Button for M waypoints

[Machalot]

Page 197 of the Viggen manual says TAKT/OUT mode will display 900000 when a waypoint button is pressed and that waypoint is an M point.  I don't see this behavior.  For me, TAKT/OUT does essentially nothing, always displaying 000000 no matter what buttons I press.  Am I doing something wrong or is this a bug?

[kgd192]

Yep I have observed the same behaviour, it always shows the pylon status, regardless of whether a Waypoint button is pressed/held or not.

[Graphene]

On 1/7/2021 at 11:29 AM, Machalot said:

Page 197 of the Viggen manual says TAKT/OUT mode will display 900000 when a waypoint button is pressed and that waypoint is an M point.  I don't see this behavior.  For me, TAKT/OUT does essentially nothing, always displaying 000000 no matter what buttons I press.  Am I doing something wrong or is this a bug?

Trigger Safety Bracket  maybe

[Machalot]

2 hours ago, alex.boiarintsev said:

Trigger Safety Bracket  maybe

Does it work for you?

[Graphene]

I thought about another situation where the current coordinates are blocked by pressing the safety bracket.

Yesterday, when I flew and set the M point, then in the TAKT mode after clicking on the waypoint, zeros were really shown. I'll try check tonight.


 

Edited February 3, 2021 by alex.boiarintsev

[Graphene]

On 1/12/2021 at 12:45 AM, kgd192 said:

Yep I have observed the same behaviour, it always shows the pylon status, regardless of whether a Waypoint button is pressed/held or not.

@Machalot 

I confirm. Tested in flight, shows only the status of the pylons.

[Machalot]

Thanks for verifying. Appears to be a bug in the CK37 model. 

[Flappie]

I agree: it doesn't work.

Track attached.

 

 

AJS37_TAKT_OUT_doesn't_show_M_points.trk