Jump to content

Recommended Posts

Posted

BIT - You've got an unresolved BIT Item on the BIT page. It will be flashing, press STOP to stop flash. Or better yet, verify that system is on / operative.

 

FPAS - Probably because the FPAS system can't calculate fuel flow when in afterburner. Go to mil power or less.

Posted
16 hours ago, Tholozor said:

The FPAS advisory will appear at any time the system can't calculate the HOME FUEL caution. Calculated fuel remaining to any waypoint can only be done at true airspeeds less than Mach 0.9.

 

 

This.

Side note:  If you are going to be landing at a different location that your initial position - you can enter those coordinates as a waypoint (via HSI), then in FPAS display, press the OSB that corresponds with the 'up arrow' and select your new home plate (the number between the down and up arrows indicates waypoint number).  For example, if waypoint 5 is your new home plate - press the up arrow (on FPAS display) until the number between the down and up arrows shows 5.  (This is on the bottom right of the FPAS display).


Cheers,

 

Ziptie

  • Like 1
  • Thanks 1

i7 6700 @4ghz, 32GB HyperX Fury ddr4-2133 ram, GTX980, Oculus Rift CV1, 2x1TB SSD drives (one solely for DCS OpenBeta standalone) Thrustmaster Warthog HOTAS, Thrustmaster Cougar MFDs

 

Airframes: A10C, A10CII, F/A-18C, F-14B, F-16C, UH=1H, FC3. Modules: Combined Arms, Supercarrier. Terrains: Persian Gulf, Nevada NTTR, Syria

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...