Boneski Posted September 10, 2008 Posted September 10, 2008 Is there a Mod that allows for 3 digit side numbers for Red Aircraft? The Blue Aircraft have 3 digit tail numbers as an option. Thanks My mission is to fly, fight, and win. o-:|:-o What I do is sometimes get a tin of soup, heat it up, poach an egg in it, serve that with a pork pie sausage roll.
Deadman Posted September 10, 2008 Posted September 10, 2008 No Its hard coded to the models so no mod but if someone remakes the models it is possible https://forum.dcs.world/topic/133818-deadmans-cockpit-base-plans/#comment-133824 CNCs and Laser engravers are great but they can't do squat with out a precise set of plans.
Renato71 Posted September 10, 2008 Posted September 10, 2008 There are three possible workarounds: 1. Make a new skin and paint first (or last) digit on the skin iself 2. Create nomera file that has two digits inside the space reserved for one digit 3. Use empy (blank) nomera and paint the number directly on skin Drawbacks are that in the first option is very difficult to allign additional digit, and in the second are you cannot display all numbers. Third option does not permit any change in number (using LO). I'm selling MiG-21 activation key. Also selling Suncom F-15E Talon HOTAS with MIDI connectors, several sets. Contact via PM.
Vekkinho Posted September 10, 2008 Posted September 10, 2008 BTW, IRL 3 digit Red birds are protos or demonstrators! [sIGPIC][/sIGPIC]
Boneski Posted September 12, 2008 Author Posted September 12, 2008 Thanks guys! My mission is to fly, fight, and win. o-:|:-o What I do is sometimes get a tin of soup, heat it up, poach an egg in it, serve that with a pork pie sausage roll.
Vekkinho Posted September 12, 2008 Posted September 12, 2008 Perhaps in the future DCS modules we'll see a 3 digit nomera! [sIGPIC][/sIGPIC]
Deadman Posted September 12, 2008 Posted September 12, 2008 If you check out what Sim Mode did to the A-10 with the skin file you will see the possibilities https://forum.dcs.world/topic/133818-deadmans-cockpit-base-plans/#comment-133824 CNCs and Laser engravers are great but they can't do squat with out a precise set of plans.
Recommended Posts