Jump to content

Maverick boresighting on ground - no GND JETT ENABLE, no MASTER ARM SIM


Go to solution Solved by BIGNEWY,

Recommended Posts

Posted

Looking at Viper manual, page 281, the procedure is quite simple:

image.png

While learning this, I forgot to set GND JETT ENABLE to ON and MASTER ARM to SIM. I was able to boresight my AGM-65Ds. Only when I went to step 8 I realized I had omitted step 2. 

 

I went back in to reproduce and it does seem to ignore step 2 of the instructions - no matter if aircraft is set in ME to cold start or hot start, I am able to boresight Mavericks without step 2. 

 

In this track (~5 minutes) I showed the hot start one. Later I flew to kill some targets and had nice 6 shots / 6 kills in one pass. 

 

BORESIGHT-HOT-START.trk

Intel Ultra 9 285K :: ROG STRIX Z890-A GAMING WIFI :: Kingston Fury 64GB ::  MSI RTX 4080  Gaming X Trio  :: VKB Gunfighter MK.III MCG Ultimate :: VPC MongoosT-50 CM3 :: non-VR :: single player :: open beta

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...