ICLS Hud symbology not showing

[mstram]

I'm running the base install / caucasus / dcs world ver 2.7.2.8165.2.

 

I've set up a mission with the F18c and supercarrier, adding the 'advanced waypoint - commands' to set the ILS to ch 11, and the TACAN to ch 71.

 

I set the mission to run at time  23:00  which is triggering   a "recovery III" 

 

I start the mission, and set the tacan and ILS channels in the jet.

 

I do the radio  "inbound" ,,,  get vectored to the stack ..... hold for the appropriate time, exit and approach

the carrier at 1200 agl.

 

I've "boxed" the TCN and ILS settings in the HSI.

 

I'm within 10nm and have caled "see you at 10"

 

My hud is NOT displaying the ICLS   symbology.

 

It IS displaying the  TACAN symbology

 

 

What am I missing ?

 

**** 

Is there a way to fly a "recovery III" operation  in  daytime / clear weather ?

 

Mike

[draconus]

12 hours ago, mstram said:

Is there a way to fly a "recovery III" operation  in  daytime / clear weather ?

Yes, but not both at the same time Either clear weather at night or low vis daytime.

 

The ICLS needles should show up on the HUD at 6nm DME.

[HammerUK9]

17 hours ago, mstram said:

I start the mission, and set the tacan and ILS channels in the jet.

 

This might be a dumb question, but did you remember to hit 'ON' for the ILS as well?

[emibat]

19 ore fa, mstram ha scritto:

 

Is there a way to fly a "recovery III" operation  in  daytime / clear weather ?

 

 

At sunset. There is light but is case III

[mstram]

Fixed.

 

Issue was I had not selected the Carrier name in the "Units" field for the ICLS  advanced waypoint.

 

Re: Recov III in daylight....   I actually just wanted to use the ICLS in the daylight,  don't really care if it's a Reco III.

 

Daylight / clear ICLS now works fine

[Barra1]

just to double check, have you given the carrier's ICLS system command a name in the mission editor? This was an issue for me.