mstram Posted July 22, 2021 Share Posted July 22, 2021 I'm running the base install / caucasus / dcs world ver 2.7.2.8165.2. I've set up a mission with the F18c and supercarrier, adding the 'advanced waypoint - commands' to set the ILS to ch 11, and the TACAN to ch 71. I set the mission to run at time 23:00 which is triggering a "recovery III" I start the mission, and set the tacan and ILS channels in the jet. I do the radio "inbound" ,,, get vectored to the stack ..... hold for the appropriate time, exit and approach the carrier at 1200 agl. I've "boxed" the TCN and ILS settings in the HSI. I'm within 10nm and have caled "see you at 10" My hud is NOT displaying the ICLS symbology. It IS displaying the TACAN symbology What am I missing ? **** Is there a way to fly a "recovery III" operation in daytime / clear weather ? Mike Link to comment Share on other sites More sharing options...
draconus Posted July 23, 2021 Share Posted July 23, 2021 12 hours ago, mstram said: Is there a way to fly a "recovery III" operation in daytime / clear weather ? Yes, but not both at the same time Either clear weather at night or low vis daytime. The ICLS needles should show up on the HUD at 6nm DME. Win10 i7-10700KF 32GB RTX3060 Rift S T16000M TWCS TFRP FC3 F-14A/B F-15E CA SC NTTR PG Syria Link to comment Share on other sites More sharing options...
HammerUK9 Posted July 23, 2021 Share Posted July 23, 2021 17 hours ago, mstram said: I start the mission, and set the tacan and ILS channels in the jet. This might be a dumb question, but did you remember to hit 'ON' for the ILS as well? Link to comment Share on other sites More sharing options...
emibat Posted July 23, 2021 Share Posted July 23, 2021 19 ore fa, mstram ha scritto: Is there a way to fly a "recovery III" operation in daytime / clear weather ? At sunset. There is light but is case III [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
mstram Posted July 24, 2021 Author Share Posted July 24, 2021 Fixed. Issue was I had not selected the Carrier name in the "Units" field for the ICLS advanced waypoint. Re: Recov III in daylight.... I actually just wanted to use the ICLS in the daylight, don't really care if it's a Reco III. Daylight / clear ICLS now works fine 1 Link to comment Share on other sites More sharing options...
Barra1 Posted July 24, 2021 Share Posted July 24, 2021 just to double check, have you given the carrier's ICLS system command a name in the mission editor? This was an issue for me. Link to comment Share on other sites More sharing options...
Recommended Posts