Aernov Posted August 11, 2021 Share Posted August 11, 2021 I had target point designated (DESG boxed on EHSD) and was going to look up the locations of waypoints to find out which one marks my home base, but DATA page showed same point on the map regardless of selected waypoint, while page symbology changed according to waypoint selection (and aircraft position was shown relative to that selection too, but I am not sure it was correct). Initial DATA page for WYPT, T0 selected W1 selected - symbology changed, but map did not move W2 - same thing and W3 Also, point coordinates are shown in degrees/decimal minutes but can only be accepted by the Harrier in degrees/minutes/seconds (or MGRS/UTM). Link to comment Share on other sites More sharing options...
Hornet81 Posted August 12, 2021 Share Posted August 12, 2021 @Aernov Thanks for the report. I have added that to the internal bug system. Regards Link to comment Share on other sites More sharing options...
AlphaJuliet Posted October 28, 2021 Share Posted October 28, 2021 Should be fixed, give me a heads up if not. Cheers, Alpha Link to comment Share on other sites More sharing options...
Recommended Posts