Jump to content

Hind not lifting off?


Go to solution Solved by SnuggleFairy,

Recommended Posts

Posted

So installed the Hind and mapped the axis controls as usual. Sticks all move and the collective goes up and down in the right direction, even the swashplate on the hub can be seen moving on the outside views, BUT the thing will just not lift off or move at all?  A google search shows a few other people had this problem and the one who has replied to me cannot remember how he fixed it. Any suggestions? 

Posted

Although I do not have the Hind at the moment, I guess you should also adjust the RPM of the engine. Maybe you run your engine on too low RPM.

Posted (edited)

 The engine RPM is already set when you start in the 'instant action' scenario. I have tried adjusting the RPm just in case but again no change. What else might you suggest?

Edited by drummer
Posted

i did not know there was such an option but will check. Regardless, you would have though lifting into a hover would over ride wheel chocks?

Posted
23 minutes ago, drummer said:

i did not know there was such an option but will check. Regardless, you would have though lifting into a hover would over ride wheel chocks?

It was an issue with the Harrier. Not sure if it still is

  • Like 1

Modules: Wright Flyer, Spruce Goose, Voyager 1

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...