missing info Hellfire doesnt recognise Laser Code, re-assign Laser Codes necessary

[NWGJulian]

hi all

noticed this issue a few times today.

laser is ON (util-page), codes are set correctly and tads says i am in correct parameters for the hellfire shot (small solid box). but the small solid box doesnt get big, means the hellfires is not tracking anything.

laser is 100% ON, and i also can shoot the hellfire. but obviously its not hitting.
if i re-assign the same laser codes after deactivate and activate again the LASER and MSL under wpn->utiliz, suddenly it works. but only for like a few shots, suddenly i have to reassign laser codes again, and i get the message „REMOTE“ on the tads.

anybody else with this problem?

Edited March 18, 2022 by NWGJulian

[NineLine]

Can you supply a track of this? We can take a look.

[DerPilot22]

vor 7 Stunden schrieb NineLine:

Can you supply a track of this? We can take a look.

Same problem here. Happened in multicrew to me and a friend multiple times. After about 4-6 Hellfires the Hellfire doesnt track the laser if you try to lase before launch. If you shoot the hellfire regardless it either lands somewhere completly different and one time (maybe coincidence) it landed where my pilot had his TADS reticle (he aligned his hmd inproperly). Also a "missile not ready" and "scattered" message apeared on the TADS sometimes when this problem occured.

thx

[Siema]

Same here in multicrew 

[FalcoGer]

We had a few hellfires not tracking correctly after we changed code to 1588 for LRFD on B and then set missile priority channel to B. It just went ballistic even though when fired from constraints. Might be this, might be something else entirely.

[NWGJulian]

i will try and get a track-file, but yesterday it didnt happen once. i shot 8 hellfires without a problem.