FalcoGer Posted July 18, 2022 Posted July 18, 2022 (edited) I have a Nacon GC-100 connected in XInput mode, emulating an xbox controller. The Z axis on that controller is shared between the left and right trigger in such a way that pressing neither trigger has the axis be on 50%. I do not use this controller with DCS, so i set it to DISABLED in the control options. In the AH-64D apache, the default for the Z-Axis on that controler is the collective. If the controller is connected, then the apache starts with the collective applied 50% even though the controller is disabled. If I remove the Z-Axis assignment from the controller, the apache starts with the collective value of the controller (my thrustmaster throttle) as it should. I think the sync hotas controls doesn't check the disabled status of connected controllers. I didn't check for other aircraft, but this should not happen on any of them. Disabled means disabled. Edited July 18, 2022 by FalcoGer
Flappie Posted July 24, 2022 Posted July 24, 2022 Nice detective work! I've just made a small test and I came to the same conclusion. Issue reported. 1 ---
Recommended Posts