Fred00 Posted February 4, 2023 Share Posted February 4, 2023 (edited) I have the Warthog throttle. When I start (for example) one of the instant action missions in Georgia the HUD is set as SOI. I press UP on the coolie switch on the throttle and the HMCS is set to SOI. Now, the problem is that if I press again nothing happens. The way it is described in the manual, successive presses of coolie switch up should change SOI between HUD and HMCS. As it stands now, I can not find a way to return SOI to the HUD. Has something changed in the HOTAS logic or am I misunderstanding the manual? Edited February 4, 2023 by Fred00 Link to comment Share on other sites More sharing options...
razo+r Posted February 4, 2023 Share Posted February 4, 2023 (edited) Coolie hat down is to make HMCS SOI and Coolie hat up makes the HUD SOI. I think the logic did change at one point but I'm not too sure about that. But these commands do work. Edited February 4, 2023 by razo+r Link to comment Share on other sites More sharing options...
Solution Fred00 Posted February 4, 2023 Author Solution Share Posted February 4, 2023 Thanks for your reply. I tested it again, but ut didn't work. So just to be sure I checked the bindings. I had these: Coolie press up - mapped to down Coolie press down - mapped to nothing Seems crazy, because I have never touched the bindings for this module. Either way, I'm glad I found the problem! Link to comment Share on other sites More sharing options...
Yurgon Posted February 4, 2023 Share Posted February 4, 2023 8 hours ago, Fred00 said: The way it is described in the manual, successive presses of coolie switch up should change SOI between HUD and HMCS. Where in the manual did you find that? The table quoted by razo+r has been in the manual for a very long time. Link to comment Share on other sites More sharing options...
Recommended Posts