No Nav Data after DSMS Upload All

[TheFlyGuy]

I haven't been flying the A10-C for a While. When I startup the Aircraft, at some point I select the DSMS "Load All" Function. CDU is already initialzing at this Point. If I remember correctly this Function not only loads the Weapon Loadout, but also the Flightplan(s). Now, the Weapon Loadout gets loaded, but not the Flightplan, or any Waypoints at all. What am I missing?

[razo+r]

Do you even have a flightplan?

Or a short track?

 

[TheFlyGuy]

I have a Flightplan from the Mission Editor. 

[razo+r]

Then upload a short track so we can see what is happening.

[Yurgon]

2 hours ago, TheFlyGuy said:

Now, the Weapon Loadout gets loaded, but not the Flightplan, or any Waypoints at all.

Like razo+r said, we need a track to verify this.

But there's a common possible cause. Did you rotate the CDU STEER PT dial to FLT PLAN? It used to default to this position, but now it defaults to MISSION and in turn the TAD won't show the active flight plan unless you manually rotate it to FLT PLAN at any point during startup.

[TheFlyGuy]

That was it. Thank you very much!