reported DTC AUTO profile doesn't work as intended

[Solo_Turk]

I use cmds as Semi Auto with manual mode 1 selected. so that I can use cmd forward for countering radar guided missiles. System chooses a chaff only auto mode  for me. cmd aft would be manual 1 -flare only long duration programme-  which can be used against manpads threat while diving or egressing. And with this setup, I can also stop a started programme by pushing cmd forward. that is my setup. Now, after last dtc update, I tried to defend a SA2. S/A mode ignored my dtc setup and started to drop 2 chaff 2 flare probably 0.5 interval. none of Auto modes had flare inside them.It should have been  1 chaff 1 interval  5 repeat. after that, I chose none for SA2 threats, it still dropped chaff flare. My dtc was loaded as default when I started in the air. guard channels were enabled for checking whether dtc loaded or not. I also tried without a dtc, and with dtc auto selected, didn't make any difference.

There is one more thing that I want to mention. It used to show which manual mode selected on right of the S/A. But not anymore. I don't know whether intended or not.

none.trk auto2 1 chaff 5 rep 1 int .trk

Edited April 17 by Solo_Turk

[NineLine]

Thanks, we will take a look. 

[sandpatch]

I think this is in the F16 as well.

 

I tried to have a program where the action is none on all airborne. Still it want's me to counter as soon as a plane shows up.

 

Semi test.trk

[NineLine]

This is reported, thanks!

[Fresh]

I edited the .dtc file to set all threat to AUTO = None.. now in a test mission it will still dispense flares when an SA-2 locks me. Unfortunately I can't send a track file, they are bugged (reported)

 

Auto4.trk ALE-47 DTC Test.miz Test AUTO is NONE.dtc