Maddaawg

Remember to not upgrade to Win11 24H2 and keep that cable safe, it's not replaceable. I may have to get my G2 back out to compare, but for now I am enjoying the Q3 for other things than just DCS - I know sacrilege!

I think you downloaded the raw file. Go to builds, click on 0092 zip file then look for the 3 dots top right above where you see raw. JoyPro Download Page

Would switching the controller buttons in Oculus settings under accessibility work? You can remap the buttons and swap sticks left and right.

I gave that a shot and it still crashes. Even setting 1.1 PD in oculus tray caused it to crash at the opening screen to quick start flight. I'll leave it alone, I'm satisfied with the rest of my settings for now but I don't think a free flight is going to stress it so I may have to reduce somethings later.

Ok, thanks I'll check tonight.

So I was following a guide on YT to setup the Q3 since I had only used the Reverb G2 previously. Clean install and following the instructions in the guide I would crash at a PD of 1.2 where the uploader with the same GPU was fine at 1.3. Even lowering all my settings to low and 72hz in the Q3 it would still crash. Raising much of the settings back up higher setting DLSS either to performance or quality, textures to high, clouds to high, anisotropic to 16x it ran pretty good at a PD of 1.1. But put that to 1.2 and crash. This seems to be a hard limit for me. My specs are I9-10900k, 64GB at 3200, and a 3080ti. The uploaders system has a better AMD and memory, so maybe that's why? I've also read to leave it a 1.0 which is the native resolution. I think its fine at 1.1, I'm more curious than needing to increase it.

Thanks, I figured as much but wanted the confirmation.

I've searched this question for an hour and have a headache getting the same AI answer about 2.9 not implementing DX12 features. So, I must turn to the humans, do I need to downgrade from DX12 to DX11, if that's even possible. I know it's supposed to be backwards compatible, but I want to make sure.