Maddaawg

Ok, thanks I'll check tonight.

So I was following a guide on YT to setup the Q3 since I had only used the Reverb G2 previously. Clean install and following the instructions in the guide I would crash at a PD of 1.2 where the uploader with the same GPU was fine at 1.3. Even lowering all my settings to low and 72hz in the Q3 it would still crash. Raising much of the settings back up higher setting DLSS either to performance or quality, textures to high, clouds to high, anisotropic to 16x it ran pretty good at a PD of 1.1. But put that to 1.2 and crash. This seems to be a hard limit for me. My specs are I9-10900k, 64GB at 3200, and a 3080ti. The uploaders system has a better AMD and memory, so maybe that's why? I've also read to leave it a 1.0 which is the native resolution. I think its fine at 1.1, I'm more curious than needing to increase it.

Thanks, I figured as much but wanted the confirmation.

I've searched this question for an hour and have a headache getting the same AI answer about 2.9 not implementing DX12 features. So, I must turn to the humans, do I need to downgrade from DX12 to DX11, if that's even possible. I know it's supposed to be backwards compatible, but I want to make sure.