Maverick806

You can also use the cursor and TMS up to change the active waypoint on the HSD page.

It’s in the patch notes for the April 16th patch: Fixed: Hot/Air start should activate GPS Time.

From the guide: “Saving the DTC file saves it within the DCS mission (.miz) file, and it can then be applied to aircraft.“ Did you save the mission after creating and saving a DTC?

Interesting, there was a discussion about this a while back when this was first implemented and nobody seemed to think there was an issue with the radar only attempting to lock once TMS up was released.

The issue that fix is referencing is that the radar could previously lock targets when it was showing as off, including while in the ground, not that it could be turned off. Also, this behavior changed before the Jan 20th patch

In previous versions of DCS, Holding TMS UP while in ACM BORE mode would temporarily turn off the radar and NO RAD would be displayed on the HUD. After the Dec 24th patch, I noticed that NO RAD was no longer displayed when holding TMS UP. Steps to Test: Enter Dogfight Override Mode Press TMS FWD to enter BORE mode Press and Hold TMS FWD F16_ACM_BORE.trk

It's intentional and has already been discussed here:

According to the change logs, todays patch was to fix a crash

The patch with the FM/FCS changes hasn't been released yet. You should test again after the patch containing those improvements has been released.

DMS Down Long will still reactivate your HMCS if you turned it off that way. Is there any chance you raised your visor? That would also disable your HMCS.

In the rearm menu, check the fuzing options (Yellow Triangle in the top left corner of each station with bombs) and ensure each of the stations that have the same type of bombs, have the same type of fuze. Using your screenshot as an example, you'd need to open up the fuze settings for the GBU-12's on Stations 3,7 and 8 The "Copy to all of the same weapon" button only copies the laser code

You can also change laser codes while on the ground using the rearm menu.

It kind of sounds like the binding on your throttle is holding the canopy switch in the down position after the canopy is fully closed. If the canopy switch is being held in the down position, it will prevent the canopy handle from being closed. If you have a 3 position switch available, that might let you return the switch to the neutral position and allow you to close the canopy handle.

The other thread is tagged reported earlier

You probably won’t be able to find it on steam until the patch goes live, and the patch was slightly delayed to the 4th. The patch status is kept up to date in this thread: