[W.I.P]FLCS warning light logic

[F16FLCS-SME]

2.5.6.54046 Open Beta

 

This lamp does'nt seem to come on when it should regarding a failed FLCS BIT.

According to -1:

"The FLCS warning light also illuminates if the LEF's are locked or BIT fails. The FLCS warning light remains illuminated until FLCS reset action is successful in clearing the failure."

"the BIT runs for approximately 45 seconds. A failure during the BIT sequence or a BIT interlock failure terminates BIT, returns the switch to OFF, illuminates the red FAIL light and the FLCS warning light, and sends an FLCS BIT FAIL PFL message. BIT failures are nonresettable and the red FAIL light does not go off until a subsequent BIT is successfully completed.

Edited September 21, 2020 by F16FLCS-SME

[BIGNEWY]

Hi

 

thanks for the info, BIT is still W.I.P we should see improvement later in development.

 

thanks

[Nealius]

Is it possible to even fail a FLCS BIT with the current Viper? I've never seen it happen.

[F16FLCS-SME]

Engage it very fast, it will fail immediately.

Engage in air, same result.

The real switch requires 1 second to be engaged for the BIT subroutine to actually start.

This is simulated quite well now:thumbup:

[Nealius]

"Engage it very fast" as in very fast after engine startup?

[FoxOne007]

"Engage it very fast" as in very fast after engine startup?

I think he means as in, pushing up the switch for shorter than the 1 second he describes above. so if you just quickly click it.

[F16FLCS-SME]

Exactly, a short click.

[Nealius]

Oh....I've only ever done a quick click and never had issues.