w.i.p FCS BIT TEST

[speed-of-heat]

The FCS BIT test seems to always show ready after a cold start now ? is this new behaviour intended?  

[Hulkbust44]

The FCS BIT test seems to always show ready after a cold start now ? is this new behaviour intended?  

After initializing the BIT as part of startup?

Mobius708

[speed-of-heat]

so i go through the cold start process, and by the time i get to the part where i would initialise it , it already shows as ready... 

[Hulkbust44]

23 hours ago, speed-of-heat said:

so i go through the cold start process, and by the time I get to the part where I would initialize it , it already shows as ready... 

I might be nitpicking here but there is no "ready" indication for any BIT test. When no failures have been detected for a certain system it will display "GO" at the beginning NOT RDY will be displayed. I just did a cold start (my abridged version) then messed around with some of the BIT pages to see what works and what's WIP. In my track I did not receive an "GO"s until the FCS bit was completed. Any chance you could try to replicate and share your track?

startup_BIT.trk

[speed-of-heat]

doh im a moron PB Go  rather than just go means run the damn test ...