When loaded with 9 GBU-38s only 8 are selectable in smart weapons page.

[Tenkom]

notselecting9thjdam.trk

Track included.

Basically if I have 9 gbu-38s loaded and add them all to prog 1 in PACS. When I cycle them in the Smart weapons page one is skipped.

After I've dropped some, haven't been able to pinpoint the logic there, it does become available. So in the end i can drop them all but it seems like a bug.

Also with unlimited weapons it doesn't seem possible to drop the reloaded ones since they don't show up in the smart weapons menu.

[Zboboinator]

Same problem with GBU-31, 6 loaded but I can only cycle on 5 stations, the station L1 is ignored,

And with 9 GBU-38 is the same, the station L1 is ignored !

 

But after release all the other bomb, the Station L1 can be selected

If I select only the bomb on the fuselage, I can use the station L1 but if I select one wing station i lose the station L1

Edit 1 : to access the L1 station, use an empty program, select the L1 station, load a target and then change station, but if we return to our ammunition program, we lose the L1 station again. 

 

Edited November 16, 2023 by Zboboinator
miss an important information

[Agent_Scarn]

I didn;t have any problems with the "L" or "R" stations, I did have aproblem with the 5 (middle) station. It wouldn't cycle to it.

What I did was put the 5 station in a different PROG on it's own.

That did the trick.

[Solo_Turk]

same here!

[bfr]

I think i've had a couple of cases of where i've gone up 7 * GBU-31s loaded, everything goes swimmingly for the first 6 but the last bomb 'vanishes' off the smart weapon page when I try to release it (still on the jet, still showing in the A/G page but no bombs to be seen in the smart weapons page).  Run out of time this evening but i'll try and reproduce it and get a track file tomorrow if I can.

[D1CE]

Looks to be a general logic issue. I tested 7 GBU-31(v)1's and only 6 of them were selectable for data transfer.
I used Prog2 for that station to be selectable.

[Rhinozherous]

Also had most of the time L1 not selectable... But also other stations are skipped from time to time. 

[paura19]

Looks like wing station 1 blocks L1-1 to select.
Unselecet left wing station in A/G program.

Also 31s v3 in double configuration are invisible on aircraft.