[MULTI-DISPLAYS NOT SUPPORTED YET] No DDI images

[leacamba]

Hello, I am doing the training missions, and i dont get any imagen on the ddis. What im doing wrong?

[NineLine]

You are turning them on as instructed?

 

Please include tracks or short vid if you are sure you are turning them on correctly.

[leacamba]

[NineLine]

I tried to reproduce and its working fine for me. Are you using any sort of mods, or perhaps multi-monitor to view the DDI's on? Right now export to another monitor is not working, so might cause problems if you are trying, or have something set up for another module.

[SkateZilla]

Are you Exporting the MFDs?

[Zilch]

I'm having the same issue even in Instant Action missions with the bird already in the air.

 

Video:

 

 

Should be done processing to YT in a few minutes.

 

Also see my attached dxdiags, monitor config file and export.lua, which I suspect may be causing the issue?

 

Do I need to go back to single monitor, stop exporting MFD's for other modules, or both?

DxDiag.txt

Export.lua

PeriphGUI.lua

[NineLine]

I'm having the same issue even in Instant Action missions with the bird already in the air.

 

Video:

 

 

Should be done processing to YT in a few minutes.

 

Also see my attached dxdiags, monitor config file and export.lua, which I suspect may be causing the issue?

 

Do I need to go back to single monitor, stop exporting MFD's for other modules, or both?

 

Its not supported in the Hornet right now, so I am sure that is the issue.

[leacamba]

I tried to reproduce and its working fine for me. Are you using any sort of mods, or perhaps multi-monitor to view the DDI's on? Right now export to another monitor is not working, so might cause problems if you are trying, or have something set up for another module.

 

Yes, i was using a multi monitor setup, y try it with the one monitor setup and it works.

 

Thank u!!

[Zilch]

Thanks, gents. I retain multi-monitor for that sweet peripheral vision, but cut out the MFD export for other modules. This was set up for the A-10C and Mirage 2000. Easy fix!

 

I can't wait until these work, since I use them a lot, but at least I can explore the new bird now. Can't wait to get into it.

Edited May 31, 2018 by Zilch

[NineLine]

Thanks for the reply, sounds like that is it.

[majapahit]

4 monitors = blank DDIs

3 monitors = OK

 

duh

 

DCS?

 

 

 

EDIT:

 

just figured out what was meant here,

 

had to comment out/delete my

 

LEFT_MFCD =

{

x = 1920-10-((400*1.4)*1.35);

…

 

RIGHT_MFCD =

{

x = 3840+10;

..

 

section in the Monitor Setup file

used for A10C and Ka-50 export to left and right monitors

 

 

(and check the proper screen size / aspect ratio now calculated)

Edited May 31, 2018 by majapahit

[m4ti140]

Yea, was about to report it cause my DDIs went blank when I exported MFCDs. Looking forward to support of this function in future versions