HSI Knobs only works with Mousewheel

[Delareon]

The Crs Knob only works when you use the Mousewheel.

Every other Button, like QNH for example, works if you click left Mouse Button and then move the Mouse Left or Right

[Swift.]

I think they work by pressing and dragging right click. Similar to Hornets radar altimeter

[Bravo]

This might be because it duals up as the brightness knob as well.

I can use it with VR controllers but if i press it, it changes to adjusting brightness

[SGT Coyle]

Course and Heading work for me. I have them mapped to DirectX buttons on TM combined controller.

[SMH]

LClick-Dragging them works fine here. Maybe you're just not noticing them rotate due to the repeating pattern? (There's slightly darker markings on the left side that look like dirt but they seem to be paint to indicate where the dial is set. Starts clean then fills in left to right as the dial setting is increased.)

[imacken]

I think they work by pressing and dragging right click. Similar to Hornets radar altimeter

 

Yes! Thank you for that. Been bothering me for the last couple of weeks with left drag not working as it normally does. Who would have thought it was right-click and drag? I have the hornet radar altimeter bound to HOTAS so didn't notice that.

 

Thanks again!

[SGT Coyle]

Yes! Thank you for that. Been bothering me for the last couple of weeks with left drag not working as it normally does. Who would have thought it was right-click and drag? I have the hornet radar altimeter bound to HOTAS so didn't notice that.

 

Thanks again!

 

 

It's always been Left Click and drag for encoders. At least since A10C.

I find it funny how these things find their way to getting released.

[imacken]

It's always been Left Click and drag for encoders. At least since A10C.

I find it funny how these things find their way to getting released.

 

It’s obviously intentional as left click brings up some weird BRI (I think) symbology on the HSI.

Don’t know what that’s all about.

[imacken]

Sorry, just realised that the BRI on the dial is for brightness, so as someone above said, left-click and drag should be brightness, and right-click and drag adjusts the course and heading dials.

Brightness doesn't work atm, I guess.

[rrohde]

It’s obviously intentional as left click brings up some weird BRI (I think) symbology on the HSI.

Don’t know what that’s all about.

 

BRI = Brightness, so you can adjust the brightness of the digital HSI using the same button.

[SGT Coyle]

It might be worth putting little instructions like these in the "tool tips".

[DerekSpeare]

Sorry, just realised that the BRI on the dial is for brightness, so as someone above said, left-click and drag should be brightness, and right-click and drag adjusts the course and heading dials.

Brightness doesn't work atm, I guess.

 

 

This ^

 

 

It would be really nice if we could see the "M" button in night conditions. Does the real plane have a lighted one?

Edited October 20, 2019 by DerekSpeare