reported earlier Training mission 1 issues - start up to pick up

[Hammer1-1]

Starting the aircraft normal going through the voiceovers, when the aircraft is fully started and you can exit the mission, I tried to fly around as a test flight to see if my keybinds work. The cyclic wouldnt work as it should; matter of fact, adding power pushed the aircraft backwards. The disk animation shows the cyclic actually functioning, the cyclic animation shows its functioning properly, but the physical action as a whole gives you zero control with the cyclic. I tested the mission twice. I tested 2 separate missions in between these two tests to show my cyclic works correctly, and both times in this training mission I had no cyclic authority. Is that by design? Here are 4 tacview files that show my issue. TRNG 01 is the faulty missions. The first one I managed to get cyclic authority, but barely, and only after spinning out of control on lifting. Only happens training mission 1.

Tacview-20220705-100112-DCS-AH-64_TRNG_01_CAUC_Start.zip.acmi Tacview-20220705-101227-DCS-AH-64_TRNG_05_CAUC_Rkts.zip.acmi Tacview-20220705-102538-DCS-AH-64_TRNG_01_CAUC_Start.zip.acmi Tacview-20220705-103232-DCS-AH-64D_IA_CAUC_Cold Start.zip.acmi

Edited July 5, 2022 by Hammer1-1

[glen.a.williamson]

Apparently there may have been a problem with the last DCS update, apparently the first three AH-64D Training Missions were affected ... see below...

 

 

[Hammer1-1]

Nobody mentioned anything about whacky control issues with the cyclic, but yeah I recall that thread and couldnt find my issue mentioned.

[BIGNEWY]

game mode was enabled by mistake on some missions, it has been reported. 

The control issues will be due to game mode and also using a different control set. 

thanks

[imacken]

I'm somewhat surprised to see that these training missions are still messed up in the latest update.  Can't be used.

[Hammer1-1]

Same here, but I read there was a fix you can make with notepad++ and you can edit the mission from there.

[glen.a.williamson]

Yes, I agree this should have been corrected by now ... as it seems an easy fix.  In fact, one can easily fix this issue themselves.  You simply need to open each of these missions using the Mission Editor, and then simply save them again, I believe you will find they then work.  The Training Missions can be found on your computer at  ?\DCS World OpenBeta\Mods\aircraft\AH-64D\Missions\Training.

That is the "fix" I used. Good luck with it.  

 

 

You should also know that there is a problem with the Laser Hellfire Training mission .... do a quick search for "Training" in this forum, and you will find the problem, and the easy solution. 

 

Edited July 26, 2022 by glen.a.williamson
Can't spell any better than I can type.

[Hammer1-1]

Believe I may have corrected my training missions. Went into the ME, campaign options, unticked show labels and saved. The game mode tick box was unticked already, thinking they TRIED to fix it already but it got bugged somehow.

Edited July 26, 2022 by Hammer1-1

[imacken]

@glen.a.williamson's solution is easier. Just load and save in ME. Works for them all.

[imacken]

Fixed in today's update.