reported Drift C/O and wind

[777coletrain]

When drift C/O is selected with a crosswind and the aircraft is rolled 90° the FPM goes off the HUD. I would expect the FPM to stay where it is regardless of attitude. 

F16 FPM 4 19 23.trk

Edited April 19, 2023 by 777coletrain

[Lord Vader]

Hi @777coletrain

We have marked this for internal analysis.

Thanks.

[Chain_1]

After today's update, the pitch ladder and flight path indicator displace to the side of the HUD at around 90 degrees of bank in either direction when in DRIFT C/O.  NORM is working normally.  Track attached.

hudladder.trk

[BIGNEWY]

Hi, 

please ensure you have aligned correctly 

 

[Chain_1]

First track was from an air start so I can't check the alignment, but to help troubleshoot I tried a cold start with both a stored heading and normal alignment and the behavior persisted.  I ran a full repair, and the behavior still persists regardless of alignment or type of start.  That said, I didn't do myself any favors in the last track by doing a roll in normal mode first to show it was working properly.  Here's a track where I only use DRIFT C/O.  First I roll right and go a bit more and less than 90 degrees of bank, then I go left and do the same.  You can see the pitch ladder and flight path vector rapidly move to the top and bottom of the hud as I go to either side of 90 degrees both ways.  To be clear, the ladder is oriented correctly, i.e. perpendicular to the ground.  It did not used to behave this way.  However, if you all are seeing the ladder remain caged as it does at all other angles of bank, I guess I have a different problem.  

hudladderDRIFTCO.trk

Here's some pics to show what exactly I'm seeing.

[Moonshine]

seeing the same

 

Drift-CO-off-the-HUD.trk

[Lord Vader]

 Hi @Chain_1

This is a known issue from previous builds, it wasn't introduced with the latest update and was already reported.

But thanks for bringing this to us again. I am asking this to be merged with the previous thread.