not a bug Bug Report – DCS A-10C II Radio Frequency Issue

[Sniper2Spades]

During a mission departing from Nellis AFB with the A-10C II, I encountered a bug involving the aircraft's radios. After setting both radios to their respective tower frequencies, the ARC-210 radio automatically switches to the ARC-164 UHF frequency at a specific moment.
Here’s the sequence of actions performed:
•     Set frequency 132.55 on ARC-210
•     Set frequency 327.00 on ARC-164
•     Requested taxi clearance on 327.00 (ARC-164)
•     After receiving taxi clearance, I requested takeoff clearance on 132.55 (ARC-210)
At the exact moment I made the takeoff request via the in-game radio menu, the ARC-210 frequency was automatically overwritten and switched to 327.00, matching the ARC-164.
I’m attaching both a video and a track file to illustrate the issue.
 

Thanks

Sniper

radio_bug.trk 2025-08-20 14-41-23.mkv

[Yurgon]

Excellent report!

30 minutes ago, Sniper2Spades said:

At the exact moment I made the takeoff request via the in-game radio menu, the ARC-210 frequency was automatically overwritten and switched to 327.00, matching the ARC-164.

I'm pretty sure that has to do with the game setting "Easy Communication". With this setting enabled, radios will automatically tune to the proper frequency when you initiate a radio call.

So the ARC-210 doesn't actually match the ARC-164 here (well it does, but it couldn't care less which freq is set in the ARC-164 is my point ), it just switches to the UHF freq for Nellis Tower, because that's Tower's default frequency. It doesn't necessarily make sense that it tunes to the UHF freq when you've already dialed in the VHF AM freq, but Easy Comms is much older than the multi-mode ARC-210, which was a relatively late addition to the A-10C II (you wouldn't see this happening in the A-10C legacy module, where the front radio is another ARC-186, just like the aft radio).

Also, when you pay close attention, on your second radio call ("Request takeoff"), you had pushed Mic Switch Forward and were talking through the ARC-210; the written message in the top right corner clearly reads "ARC-210" in this case.

So, long story short, when you disable "Easy Communication" in the game's options, this will no longer happen.

Or, to cross check, you can do the same sequence of events, but before you initiate the "Request takeoff" call, switch the ARC-164 to any other freq. The ARC-210 is still going to tune Nellis Tower on UHF, regardless of what's set in the ARC-164.

[BIGNEWY]

You can find the easy comms option in the mission options 

[Sniper2Spades]

Thank you, and sorry—I hadn’t fully understood the Easy Comm option. I’m sorry for wasting your time