UH-60L Black Hawk Mod ("Official" Thread)

[Blackwood]

vor 14 Stunden schrieb MAXsenna:

@Blackwood Apologies! But this is a you problem. Like others have written, READ the manual. I had no issues with the first release of this module back in the days. Because I read the manual, before I tried to start it up. I always do cold starts. Also check for possible axis conflicts. 

I take it you're not native to English, (neither am I), and that's the reason you come off as a little entitled and demanding. No harm, lots of stuff gets lost in translation.  

Cheers! 

Thanks. Yes, I barely understand English. Except for a few words and sentences. Perhaps I expressed myself a bit unclearly. Sorry. Still, constantly reading "It works for me" or "Read the manual" instead of providing real solutions doesn't help anyone. To get back to the topic: If I'm flying the helicopter freely on a map, hovering the mouse over each switch, etc., and see that you can move those two black levers with the mouse, I assume you can use them in a cold boot. This isn't the case. So, my post was justified.

[H60MTI]

I'd try what you're talking about in game but my game doesn't even load right now so maybe someone can verify this for me...I'm assuming you need to right click on each of the PCL's once NG is on the rise to "click" the PCL into idle. I wouldn't try using the scroll wheel due to the fact you might go past idle. Try that and see what happens.

[Ithronwise]

Here is a short video that shows all the steps you need to do to cold start the engines:

 

[SolvableAlmond]

On 9/21/2025 at 1:34 PM, Kinkkujuustovoileipä said:

Read the sentence again

"Each provides roughly 50% of the control authority exercised by the system".

Ahhh… I get what you meant now. Yes, I should’ve read that more carefully. Also, I found the “Night After Christmas” poem in the FM file. Freakin’ hilarious.