extremely bad gfx glitch, MT

[Hammer1-1]

Check out the screenshots. So far only in the Apache, and in MT. Didnt experience this much, but that could change. Not sure whats coming from, but DXDiag is posted below. Using HP Reverb G2, WMR and not through steam.

edit: seens its not just Apache related too, its spazzed out in the harrier too.

DxDiag.txt Screen_230609_223650.bmp Screen_230609_223616.bmp

Edited June 10, 2023 by Hammer1-1

[speed-of-heat]

those sort of artefacts looks like the result of an unstable overclock /undervolt on the gpu, or maybe a dodgy cable on the headset?  

[Hammer1-1]

Nope. Only happens in MT. I just flew a 30 minute session without any issues in ST.

[Nealius]

Do you have motion blur turned on?

[SkateZilla]

Which Rendering Runtime's are you using?
(ie what's your DCS Shortcut and Arguments)
(ie ie "root:\Path\DCS.exe" --force_enable_VR --force_openXR)

[Hammer1-1]

"B:\DCS World OpenBeta\bin-mt\DCS.exe"

not launching it from anything other than a desktop shortcut I pulled from that address. No arguments, no commands after the target, just set in VR enabled in settings only.

1 hour ago, Nealius said:

Do you have motion blur turned on?

I believe I do...Ill double check, but take it as yes for the moment.

edit: nope, do not.

Edited June 10, 2023 by Hammer1-1

[SkateZilla]

try adding the argument to force openXR,
But it looks like it could be a GPU Issue.

ST vs MT, MT will pull more power to the CPU and Load the PSU More.

[zildac]

As @speed-of-heat mentioned, are you overclocking the CPU and/or the GPU? If the former then I would suggest that MT is utilising more cores (as it's supposed to) and therefore the OC is having a negative impact (heat likely).

[Hammer1-1]

I literally do not have this issue in single thread or any other vr related app, and this is new as of this latest patch. video card isnt overclocked, and the cpu is pretty much at stock speeds too.

58 minutes ago, SkateZilla said:

try adding the argument to force openXR,
But it looks like it could be a GPU Issue.

ST vs MT, MT will pull more power to the CPU and Load the PSU More.

Ill give that a shot in the morning, but I havent had much issues with vr up until now. nothing on my system has changed in the last 2-3 months except my motherboard. 100% confident my hardware is not the problem. edit: have it running with the force xr argument, no change.

Ill post a video of it soon...heres what I am seeing: Upper left corner, I see the cockpit. It moves along just fine, but the instrument panel graphics are just glitching all over the place. The cockpit is out of position, the instrument panel layouts are at the bottom of the screen, and its 100% bugged DCS. Ill get that video up.

edit: give it a few minutes to process, heres the link.

 

Edited June 10, 2023 by Hammer1-1

[Hammer1-1]

Ok, something new. Two settings I changed: mistakenly I did have motion blur turned up; apparently DCS MT loads up a different set of config files, and I had motion blur turned up all the way. I dont have it on in the ST version. The other setting was I also had MSAA @ 4x and I dialed it down to 2x. One of those two settings in MT is borked, and since someone mentioned it earlier its most likely motion blur.

Edited June 10, 2023 by Hammer1-1