check airleron trim neutral light Controller deadzone/curves don't activate until mid-flight; uncommanded left roll

[Nealius]

After takeoff my stick deadzones and curves are not applied, and the roll axis in particular is extremely twitchy. There is also some uncommanded left roll which disappears some time during climbout. It isn't until I'm established level at 15,000ft that my deadzones and curves are applied.

Large track so hosting on Google Drive, flown on Germany map.

[NineLine]

Based on feedback from the team, after a cold start and AFCS check, you will need to manually set airleron trim to neutral. This might be what you are seeing. Let us know. Thanks!

[Nealius]

4 hours ago, NineLine said:

you will need to manually set airleron trim to neutral.

I did immediately after the AFCS check. All three neutral trim lamps were lit. However when I do so, I always need significant left trim until that lamp illuminates. Additionally, trim setting should not affect deadzone/curve application, should it?

Tim neutral just before takeoff on the above track:

Edited Wednesday at 12:26 AM by Nealius

[Derbysieger]

@BIGNEWY I ovbserve the same behaviour. Checking the control indicator that was introduced with the patch today showed that the center point for aileron trim appears to be at the precise point where the light comes on at the panel. If you trim for center after the AFCS check and trim it a little further than that, it introduces left aileron trim according to the indicator.

 

First image: Light is still off - Trim is almost perfectly center:

Second and third image: I tap the trim hat left once. Light comes on but the control indicator already indicates a very slight aileron trim to the left

Aileron_Trim_CWG_Fulcrum.trk

Edited Wednesday at 05:20 PM by Derbysieger
Edited with explanation of the images

[Nealius]

Now that we have the controls indicator I've noticed this as well. The aileron trim "neutral" zone has a left bias. 

It also seems like the deadzone/curve issue, or twitchiness, on takeoff is caused by wind. If I run a mission with 0-2kts of wind I have no issues. When I run a mission with 5-10kts of wind, it's like the deadzone/curves aren't applied and my wings rock with the slightest inputs.